2. Windows XL Driver
2-5 Output Tab
■Output to:
Specifies the location of ejection of printed copies.
Selection is possible when the optional Job Separator and or Finisher are installed.
[Inner Tray] | Copies will be ejected onto the Inner tray. |
[Separator Tray] | Copies will be ejected into the optional Job Separator. |
[Finishing Tray] | Copies will be ejected into the optional Finisher. (Only available in the 20 ppm copier) |
*In order to set the location of ejection for the Job Separator or Finisher, it is necessary to first perform the setting for that optional equipment under “Device Options” on page
*Paper sizes and types that are acceptable for use with the Job Separator are as follows:
Paper sizes: Letter (8 1/2" x 11"), Legal (8 1/2" x 14"), Ledger (11" x 17"), Statement (5 1/2" x 8 1/2"), A3, A4, A5, Folio (210 mm x 330 mm), JIS B4 and JIS B5
Paper types: Plain, Letterhead, Recycled and Color
* Paper sizes, types and source of paper feed that are acceptable for use with the Finisher are as follows:
Paper sizes: Letter (8 1/2" x 11"), Legal (8 1/2" x 14"), Ledger (11" x 17"), A3, A4, Folio (210 mm x 330 mm), JIS B4 and JIS B5
Paper types: Plain, Letterhead, Recycled and Color
Source of paper feed: Any tray EXCEPT the Bypass Tray
■Copies
Specifies the number of prints to be made. Select between 1 and 999 copies by clicking on the arrows at the right of the field or by typing the desired number directly into the field. The factory default setting is “1”.
■Collate
When you are printing more than one copy of one or more pages, it is possible to sort the printed copy sets.
*It is necessary to create a RAM disk. (Refer to “RAM disk” on page
*If you select to turn on the “Staple” setting below, it is necessary to select “Collate” here.
Example: If the “Collate” option is selected, it is possible to print out 2 sets of the same copies.
■Staple
Stapling is possible if the optional finisher is installed.
*Stapling is only available with 20 ppm copiers.
*The following settings are required before stapling is possible:
(1)“Device Options” setting in the “Device Settings” Tab Select “Internal Finisher” and “RAM Disk”.
(2)“Output” Tab
Select “Finishing Tray” as the “Output to” setting and select “Collate” as well.
*Paper sizes, types and source of paper feed that are acceptable for stapling are as follows:
Paper sizes: Letter (8 1/2" x 11"), Legal (8 1/2" x 14"), Ledger (11" x 17"), A3, A4, JIS B4 and JIS B5
Paper types: Plain, Letterhead, Recycled and Color
Source of paper feed: Any tray EXCEPT the Bypass Tray
Note
The location of the staples will depend upon the orientation of the paper and the direction of the printed image. Thus, when you click on either of the options (“Upper Left” and “Upper Right”) a message will be displayed in order to verify the orientation of the paper.