IBM Printing System manual Receive dump mode

2. Printer Settings (20 ppm copier)

Item No.	Item	Display message	Available settings	Remarks
55	Receive dump mode	Print HEX-DUMP	OK
	The data that the printer receives for
	debugging programs and files is turned into
	hexadecimal code and printed out. If “OK” is
	selected here, this receive dump mode will
	be activated. The receive dump mode will be
	canceled under the following circumstances:
	• Form feed is initiated (by selecting the
	“GO” command in the printer mode and
	then pressing the Enter key).
	• A force-print time-out occurs.
56	Printer reset	Printer Reset	OK
	Resets the Printer Board only even without
	turning the power to the machine OFF.
57	Resource protect mode	Resource pro.	Off, Permanent,	At least 16 MB of additional
	Protects the resource data of fonts and		Per/Temp	memory (option) must be installed.
	macros downloaded through PCL6 and,
	even if the emulation protocol is switched,
	the PCL resource will be saved in the
	printer’s memory. If “Permanent” is selected
	here, temporary resources will not be saved.
	If, however, “Per/Temp” is selected,
	temporary resources will also be saved.
58	Auto Continue ON/OFF	Auto Continue	On, Off
	If one of the following error messages
	appears and “On” has been selected here,
	the error state will be released and the
	printing operation will be restarted
	automatically after a specified amount of
	time.
	“Memory overflow”
	“Print overrun”
59	Recovery time for Auto Continue	Change #	000 - 495 (sec.)	Displayed only when “On” is
	Sets the amount of time before Auto			selected under the “Auto Continue
	Continue engages when “On” is selected			ON/OFF” setting (item No.: 58).
	under the “Auto Continue ON/OFF” setting
	(item No.: 58). If “000” seconds is selected
	here, Auto Continue will engage immediately
	after the error.
60	Service Rep Status Page print out	Print Status page	No, Print
	Prints out a Status Page for use by your
	service representative.

2-12