Fujitsu MAS3367FC, MAS3735FC manual Important Alert Items

Important Alert Items

Task	Alert message	Page
Mounting Installation	Damage	5-5
	1. When dismounting the drive which is mounted on the system
	while power is supplied to it.
	• The drive to be dismounted must be separated from the
	loop. Dismounting the drive which is not separated from
	the loop may cause an unexpected error.
	• If the drive is not separated from the loop, issue an LPB to
	the drive from the initiator in a primitive sequence of the
	order set.
	• It is recommended to stop the spindle motor prior to this
	loop separation operation. The spindle motor can be
	stopped by a START/STOP command. It takes about 30
	seconds for the spindle motor to stop completely.
	• Then, dismount the drive using the drive
	mounting/dismounting mechanism, etc. of the system. If
	the drive is dismounted while the spindle motor is running,
	special care is required to avoid excessive vibration or
	shock to the drive. It is recommended to stop the operation
	once the SCA connector breaks off contact and wait until
	the spindle motor stops (about 30 seconds) before dismount
	the drive.
	• When storing or transporting the drive, put it in an
	antistatic bag. (Shown in Section 5.1).
	2. When dismounting the drive which is mounted on the system
	while power is not supplied to it.
	• Do not move the drive until the drive stops completely
	(about 30 seconds if the spindle motor was stopped by a
	START/STOP UNIT command, and about 30 seconds after
	powering-off when the power was simply turned off).
	• Then, dismount the drive using the drive
	mounting/dismounting mechanism, etc. of the system.
	• When storing or transporting the drive, put it in an
	antistatic bag. (Shown in Section 5.1).
	Data loss	6-4
	When the SEND DIAGNOSTIC command terminates with the
	CHECK CONDITION status, the INIT must collect the error
	information using the REQUEST SENSE command. The RECEIVE
	DIAGNOSTIC RESULTS command cannot read out the error
	information detected in the self-diagnostics.
	Caution	6-5
	1. To avoid injury, do not touch the mechanical assembly during
	disk drive operation.
	2. Do not use solvents to clean the disk drive.

vi C141-E198