Installation Requirements
c)Tightening torque of screw must be secured with 0.59N· m (6kgf· cm) ± 12%.
d)Impact caused by the electric driver must be within the device specifications.
e)Must be handled on an
5.0 or less 5.0 or less
Figure 4.3 Mounting frame structure
(2)Limitation of
Mount the IDD using the 4 screw holes at the both ends on the both sides as shown in Figure 4.4. Do not use the center hole by itself.
In case of using the center hole, it must be used in combination with 2 holes on both ends. (Total 6 screws for 6 holes enclosed)
4
Holes for mounting screw.
3
2
Do not use center holes.
| 1 |
| Holes for mounting screw |
|
| ||
|
|
|
|
Use four holes