Fujitsu FP-410 user manual Connecting the AC Adapter

Page 10

3-3. Connecting the AC Adapter

Note:

To connect or disconnect the AC adapter, turn off the power switches of the printer and all the devices to be connected to the printer. Then, unplug the plug of the AC adapter power cable from the electrical outlet.

(1)Connect the AC adapter to the AC adapter power cable.

Note:

Use only the specified AC adapter and specified AC adapter power cable.

(2)Connect the cable connector of the AC adapter to the printer connector.

Note:

Remove notch of connector cover with Nipper, to maintain the space for the cable of AC adopter. Otherwise, it would cause the failure because of cable broken.

(3) Connect the plug of the power cable to electrical outlet.

Connector cover

Cable connector of AC adapter

Note:

To disconnect the cable connector of the AC adapter from the printer connector, hold and pull the cable connector. The connector can be easily unlocked and pulled out. Do not disconnect the connector by pulling on the cable. Otherwise, the connector might be damaged.

9

Image 10

Contents USER’S Manual X0KA02001-Y911-02Copyright 2002 Fujitsu Isotec Limited Table of Contents Appearance and Names of Components Interface connector Serial interface Roll Paper specification Thermal paper Consumable Parts and AC AdapterAC adapter option Connecting Cables and AC Adapter Connecting the Interface CableConnecting the Drawer Kick Cable Connecting the AC Adapter Turning on the Power Control Panel Error IndicationControl Panel Loading the Roll Paper Loading the roll paperPage English Removing the Paper Roll Preventing Paper Jams Clearing a Paper JamPeriodic Cleaning Cleaning the Thermal HeadConditions for Use Page English Inhaltsverzeichni Erscheinung und Teilebezeichnungen Page Hinweis Wärmeempfindliches PapierEinzelblatt-Spezifikationen Wärmeempfindliches Papier Wechselstromadapters optionKabelanschluss an einen Wechselstromadapter Anschließen des SchnittstellenkabelsAnschließen des Einschub-Kick-Kabels Anschließen des Wechselstromadapters Hinweis Einschalten der Stromzufuhr Bedienfeld Anzeigeleuchten und SchalterFehleranzeige Papier einfüllen Papier einfüllenHinweis Hinweise Entfernen der Papierrolle Verhindern von Papierstaus Lösen von PapierstausPeriodische Reinigung Reinigung des ThermodruckkopfesBenutzungsbedingungen Page Deutsch Appendix a Specifications General SpecificationsOutline drawing AppendixSpecifications of Interfaces Cutter SpecificationsSpecifications of Paper Supply Specifications of Environmental ConditionsSpecifications of Reliability Black mark specification Printer with black mark sensor onlyPage Specifications of transmission interface Serial InterfaceInput Receive data Input Data set ready Signal ground UnusedOutput Send data Output Send requestTXD RXD RTS CTS DSR DTR Parallel Interface Forward channelReverse channel Drawer Kick Connector Type-B Connector 4PinType-A Connector 8Pin USB InterfaceDrawer connection Printer 1 Cable Drawer connection Printer Cable DrawerAppendix Appendix C Special Modes Test PrintingExample of contents of HEX dump test printing HEX DumpSetting up the Printer Setup group items Setup items Memory switch Power on Status Disable EnableSetup Items Memory Switch setup itemsSerial Interface Condition setup items Other setup items Address your comments and inquiries on this manual to