Fujitsu FP-410 user manual Drawer connection Printer 1 Cable

<Drawer connection 1>

Printer 1 Cable

2

3

4

5

6

1Drawer

2	Drawer kick solenoid
	(24	Ω minimum)
3

4

Drawer

5open/close switch

6

APPENDIX

Notes:

1.Use a shielded drawer cable.

2.Two drives cannot be driven simultaneously.

3.The drawer on/off time must be specified using t1 and t2 in the pulse generation command (ESC p m t1 t2).

4.The drawer drive duty must be as follows:

ON-time/(ON-time + OFF-time) ≤ 0.2

5.The drawer power must always be supplied from the printer power supply unit via connector pin 4.

6.The resistance of the drawer kick solenoid must be at least 24 Ω. If a solenoid with a lower resistance is used, the solenoid might be destroyed by over current.

50