Fujitsu FP-410 user manual Setup Items, Memory Switch setup items

C-4 Setup Items

(1) MEMORY SWITCH setup items

No.	Item	Explanation	Detail Setup Item
1	POWER ON	-Specifies reporting the power-on	ENABLE
	STATUS	state.	DISABLE
2	RECEIVE	-Specifies the capacity of the receive	45BYTE
	BUFFER	buffer.	4KBYTE
3	BUSY	-Specifies conditions that determine	BUFFERFULL
	CONDITION	the printer busy status.	OFFLINE/BUF-FER
			FULL
4	RECEIVE	-Specifies how to handle receive
	ERROR	errors	IGNORE
		-This item is valid only for the serial	?PRINT
		interface.
5	AUTO LF	-Specifies automatic line feed using	ENABLE
		the CR code.
		-This item is valid only for the Parallel	DISABLE
		interface.
6	DSR(#6)RESET	-Specifies the reset operation using
		the DSR(#6) signal.	ENABLE
		-This item is valid only for the serial	DISABLE
		interface.
7	INIT(#25)	-Specifies the reset operation using
	RESET	the INIT(#25) signal.	ENABLE
		-This item is valid only for the serial	DISABLE
		interface.
8	INIT(#31)	-Specifies reset using the INIT(#31)	ENABLE
	RESET	signal.
		-This item is valid only for the Parallel	DISABLE
		interface.
9	BM CHECK AT	-Specifies the adjustment of the
	POW-ON	leading edge of the paper at	ENABLE
		power-on.
		-This item is valid only when the black	DISABLE
		mark detection unit is installed and
		"BM sensor installed" is set.
10	COVER OPEN	-Specifies how to handle a cover open	AUTO RECOVERY
	ERROR	error during printing.	RECOVERY BY
			CMND
11	RETURN TO	-Returns the menu to the selection
	UP	mode for setup group items.
12	RETURN TO	-Returns the menu to the setup mode
	SETUP MENU	menu.

57