Fujitsu FP-410 user manual Connecting Cables and AC Adapter, Connecting the Interface Cable

Page 8

3. Connecting Cables and AC Adapter

To connect or disconnect these cables, turn off the power switches of the printer and all the devices to be connected to the printer, and then unplug the plug of the AC adapter power cable from the electrical outlet.

Note:

Interface cable and cable for AC Adapter is not included in the box. Please buy them when you need.

3-1. Connecting the Interface Cable

Remove the connector cover at the rear of the printer. And connect the interface cable to the rear connector.

Note:

Remove notch of connector cover with Nipper, to maintain the space for the cable of interface cable. Otherwise, it would cause the failure because of cable broken.

Connector cover

Serial interface cable * After connecting the cable, secure it with the two screws.

Parallel interface cable *After connecting the cable, secure it with the clips.

7

Image 8
Contents USER’S Manual X0KA02001-Y911-02Copyright 2002 Fujitsu Isotec Limited Table of Contents Appearance and Names of Components Interface connector Serial interface Roll Paper specification Thermal paper Consumable Parts and AC AdapterAC adapter option Connecting Cables and AC Adapter Connecting the Interface CableConnecting the Drawer Kick Cable Connecting the AC Adapter Turning on the Power Control Panel Error IndicationControl Panel Loading the Roll Paper Loading the roll paperPage English Removing the Paper Roll Preventing Paper Jams Clearing a Paper JamPeriodic Cleaning Cleaning the Thermal HeadConditions for Use Page English Inhaltsverzeichni Erscheinung und Teilebezeichnungen Page Wärmeempfindliches Papier Einzelblatt-Spezifikationen Wärmeempfindliches PapierHinweis Wechselstromadapters optionKabelanschluss an einen Wechselstromadapter Anschließen des SchnittstellenkabelsAnschließen des Einschub-Kick-Kabels Anschließen des Wechselstromadapters Hinweis Einschalten der Stromzufuhr Fehleranzeige Anzeigeleuchten und SchalterBedienfeld Papier einfüllen Papier einfüllenHinweis Hinweise Entfernen der Papierrolle Verhindern von Papierstaus Lösen von PapierstausPeriodische Reinigung Reinigung des ThermodruckkopfesBenutzungsbedingungen Page Deutsch Appendix a Specifications General SpecificationsOutline drawing AppendixCutter Specifications Specifications of Paper SupplySpecifications of Interfaces Specifications of Environmental ConditionsSpecifications of Reliability Black mark specification Printer with black mark sensor onlyPage Specifications of transmission interface Serial InterfaceInput Data set ready Signal ground Unused Output Send dataInput Receive data Output Send requestTXD RXD RTS CTS DSR DTR Parallel Interface Forward channelReverse channel Type-B Connector 4Pin Type-A Connector 8PinDrawer Kick Connector USB InterfaceDrawer connection Printer 1 Cable Drawer connection Printer Cable DrawerAppendix Appendix C Special Modes Test PrintingExample of contents of HEX dump test printing HEX DumpSetting up the Printer Setup group items Setup items Memory switch Power on Status Disable EnableSetup Items Memory Switch setup itemsSerial Interface Condition setup items Other setup items Address your comments and inquiries on this manual to