Fujitsu FP-410 Output Send data, Input Receive data, Output Send request, Input Send permission

Page 46

RS-232C connector

Pin No.	Signal	I/O	Function
	name	direction
1	FG	--	Frame ground
2	TXD	Output	Send data
3	RXD	Input	Receive data
4	RTS	Output	Send request
5	CTS	Input	Send permission
6	DSR	Input	Data set ready
7	SG	--	Signal ground
8 to 12	N.C.	--	Unused
13	SG2	Input	+24 V ground
14	SG2	Input	+24 V ground
15 to 17	N.C.	--	Unused
18	+24V	Input	Power supply for mechanism drive
19	+24V	Input	Power supply for mechanism drive
20	DTR	Output	Data terminal ready
21 to 24	N.C.	--	Unused
25	INIT	Input	Forced reset

Notes:
1.	To supply power from the power connector, do not connect the pins
	shaded(	)in the above table.
2.	Use inch- screws to secure the connection.
	13	12		11	10	9	8	7		6	5	4	3	2	1
	25		24	23		22	21	20	19	18	17	16	15		14

Connecting side

45

Image 46

Contents USER’S Manual X0KA02001-Y911-02Copyright 2002 Fujitsu Isotec Limited Table of Contents Appearance and Names of Components Interface connector Serial interface Roll Paper specification Thermal paper Consumable Parts and AC AdapterAC adapter option Connecting Cables and AC Adapter Connecting the Interface CableConnecting the Drawer Kick Cable Connecting the AC Adapter Turning on the Power Control Panel Error IndicationControl Panel Loading the Roll Paper Loading the roll paperPage English Removing the Paper Roll Preventing Paper Jams Clearing a Paper JamPeriodic Cleaning Cleaning the Thermal HeadConditions for Use Page English Inhaltsverzeichni Erscheinung und Teilebezeichnungen Page Hinweis Wärmeempfindliches PapierEinzelblatt-Spezifikationen Wärmeempfindliches Papier Wechselstromadapters optionKabelanschluss an einen Wechselstromadapter Anschließen des SchnittstellenkabelsAnschließen des Einschub-Kick-Kabels Anschließen des Wechselstromadapters Hinweis Einschalten der Stromzufuhr Bedienfeld Anzeigeleuchten und SchalterFehleranzeige Papier einfüllen Papier einfüllenHinweis Hinweise Entfernen der Papierrolle Verhindern von Papierstaus Lösen von PapierstausPeriodische Reinigung Reinigung des ThermodruckkopfesBenutzungsbedingungen Page Deutsch Appendix a Specifications General SpecificationsOutline drawing AppendixSpecifications of Interfaces Cutter SpecificationsSpecifications of Paper Supply Specifications of Environmental ConditionsSpecifications of Reliability Black mark specification Printer with black mark sensor onlyPage Specifications of transmission interface Serial InterfaceInput Receive data Input Data set ready Signal ground UnusedOutput Send data Output Send requestTXD RXD RTS CTS DSR DTR Parallel Interface Forward channelReverse channel Drawer Kick Connector Type-B Connector 4PinType-A Connector 8Pin USB InterfaceDrawer connection Printer 1 Cable Drawer connection Printer Cable DrawerAppendix Appendix C Special Modes Test PrintingExample of contents of HEX dump test printing HEX DumpSetting up the Printer Setup group items Setup items Memory switch Power on Status Disable EnableSetup Items Memory Switch setup itemsSerial Interface Condition setup items Other setup items Address your comments and inquiries on this manual to