Fujitsu FP-410 user manual Txd Rxd Rts Cts Dsr Dtr

Page 47

Connection cables

(1) The following cable connection configuration is recommended:

Host

FG <

>FG Printer

 

TXD<

>TXD

 

RXD<

>RXD

 

RTS<

>RTS

 

CTS<

>CTS

 

DSR<

>DSR

 

DTR<

>DTR

 

SG <

>SG

(2)To supply power via the interface connector, use a cable with suitable wire diameter and length so power is not reduced.

46

APPENDIX

Image 47
Contents X0KA02001-Y911-02 USER’S ManualCopyright 2002 Fujitsu Isotec Limited Table of Contents Appearance and Names of Components Interface connector Serial interface Consumable Parts and AC Adapter Roll Paper specification Thermal paperAC adapter option Connecting the Interface Cable Connecting Cables and AC AdapterConnecting the Drawer Kick Cable Connecting the AC Adapter Turning on the Power Control Panel Error IndicationControl Panel Loading the roll paper Loading the Roll PaperPage English Removing the Paper Roll Clearing a Paper Jam Preventing Paper JamsCleaning the Thermal Head Periodic CleaningConditions for Use Page English Inhaltsverzeichni Erscheinung und Teilebezeichnungen Page Wechselstromadapters option Wärmeempfindliches PapierEinzelblatt-Spezifikationen Wärmeempfindliches Papier HinweisAnschließen des Schnittstellenkabels Kabelanschluss an einen WechselstromadapterAnschließen des Einschub-Kick-Kabels Anschließen des Wechselstromadapters Hinweis Einschalten der Stromzufuhr Fehleranzeige Anzeigeleuchten und SchalterBedienfeld Papier einfüllen Papier einfüllenHinweis Hinweise Entfernen der Papierrolle Lösen von Papierstaus Verhindern von PapierstausReinigung des Thermodruckkopfes Periodische ReinigungBenutzungsbedingungen Page Deutsch General Specifications Appendix a SpecificationsAppendix Outline drawingSpecifications of Environmental Conditions Cutter SpecificationsSpecifications of Paper Supply Specifications of InterfacesBlack mark specification Printer with black mark sensor only Specifications of ReliabilityPage Serial Interface Specifications of transmission interfaceOutput Send request Input Data set ready Signal ground UnusedOutput Send data Input Receive dataTXD RXD RTS CTS DSR DTR Forward channel Parallel InterfaceReverse channel USB Interface Type-B Connector 4PinType-A Connector 8Pin Drawer Kick ConnectorDrawer connection Printer 1 Cable Drawer Drawer connection Printer CableAppendix Test Printing Appendix C Special ModesHEX Dump Example of contents of HEX dump test printingSetting up the Printer Power on Status Disable Enable Setup group items Setup items Memory switchMemory Switch setup items Setup ItemsSerial Interface Condition setup items Address your comments and inquiries on this manual to Other setup items