Fujitsu FP-410 user manual Serial Interface Condition setup items

Note:

If connecting this product to a Windows PC via the serial interface, do not select "DSR(#6)RESET: ENABLE ."

If "Valid" is selected, this product might not operate even if the printer power is turned on. In this case, turn off the power, disconnect the interface cable from the printer, turn the power back on, and select "DSR(#6)RESET: DISABLE" in setup mode.

"DSR(#6)RESET: ENABLE" is supplied only for special specifications.

(2) CUSTOMIZE VALUE setup items

No.	Item	Explanation	Detail setup item
1	USER NV	-Capacity of the user NV	1KBYTE 64KBYTE,
	MEMORY	memory	128KBYTE		192KBYTE
2	NV GRAPHIC	-Capacity of the NV graphic	None 64KBYTE 128KBYTE
	MEMORY	memory	192KBYTE		256KBYTE
			320KBYTE		384KBYTE
3	PRINT WIDTH	-Width of paper	58mm
			80mm
4	PRINT DENSITY	-Print density	70% 75% 80% 85% 90%
			95%	100%	105%	110%
			115% 120% 125% 130%
5	PRINT COLOR	-Print colors
		-The color specification	MONO
		command is invalid unless
			TWO
		"Dual-tone" is specified for this
		item.
6	RETURN TO UP	-Returns to the selection mode
		for the setup group items.
7	RETURN TO	-Returns to the setup menu.
	SETUP MENU

(3) SERIAL INTERFACE CONDITION setup items

No.	Item	Explanation	Detail setup item
1	BAUDRATE	-Baud rate	2400BPS		4800BPS
			9600BPS		19200BPS
			38400BPS		57600BPS
2	FORMAT	-Data format	7EVEN1	7ODD1
			8NONE1		8EVEN1
			8ODD1
3	PROTOCOL	-Buffer control protocol	XON/XOFF
			DSR/DTR
4	RETURN TO UP	-Returns to the selection mode
		for the setup group items.
5	RETURN TO	-Returns to the setup mode.
	SETUP MENU

APPENDIX

58