Fujitsu FP-410 user manual Cutter Specifications, Specifications of Paper Supply

Page 42

A-2. Cutter Specifications

Cutting method: Partial cut (A portion of the paper is not cut).

Note: Full-cut mode is not supported.

A-3. Specifications of Paper Supply

(1)Supply method: Manual placement

(2)Paper near-end: Detection of paper near end.

A-4. Specifications of Interfaces

(1)RS-232C

(2)Conforms to IEEE1284

(3)USB

A-5. Specifications of Environmental Conditions

(1) Temperature

 

Operating:

5ºC to 40ºC

Standby:

-5ºC to 60ºC

Storage(When packed): -20ºC to 60ºC

(2) Humidity

 

Operating:

10% to 85%RH

Standby:

8% to 95% RH

Storage (When packed): 5% to 95% RH

Note: No Condensation

(3) Maximum wet-bulb temperature: 29ºC or less

41

Image 42
Contents USER’S Manual X0KA02001-Y911-02Copyright 2002 Fujitsu Isotec Limited Table of Contents Appearance and Names of Components Interface connector Serial interface Roll Paper specification Thermal paper Consumable Parts and AC AdapterAC adapter option Connecting Cables and AC Adapter Connecting the Interface CableConnecting the Drawer Kick Cable Connecting the AC Adapter Turning on the Power Error Indication Control PanelControl Panel Loading the Roll Paper Loading the roll paperPage English Removing the Paper Roll Preventing Paper Jams Clearing a Paper JamPeriodic Cleaning Cleaning the Thermal HeadConditions for Use Page English Inhaltsverzeichni Erscheinung und Teilebezeichnungen Page Hinweis Wärmeempfindliches PapierEinzelblatt-Spezifikationen Wärmeempfindliches Papier Wechselstromadapters optionKabelanschluss an einen Wechselstromadapter Anschließen des SchnittstellenkabelsAnschließen des Einschub-Kick-Kabels Anschließen des Wechselstromadapters Hinweis Einschalten der Stromzufuhr Anzeigeleuchten und Schalter BedienfeldFehleranzeige Papier einfüllen Papier einfüllenHinweis Hinweise Entfernen der Papierrolle Verhindern von Papierstaus Lösen von PapierstausPeriodische Reinigung Reinigung des ThermodruckkopfesBenutzungsbedingungen Page Deutsch Appendix a Specifications General SpecificationsOutline drawing AppendixSpecifications of Interfaces Cutter SpecificationsSpecifications of Paper Supply Specifications of Environmental ConditionsSpecifications of Reliability Black mark specification Printer with black mark sensor onlyPage Specifications of transmission interface Serial InterfaceInput Receive data Input Data set ready Signal ground UnusedOutput Send data Output Send requestTXD RXD RTS CTS DSR DTR Parallel Interface Forward channelReverse channel Drawer Kick Connector Type-B Connector 4PinType-A Connector 8Pin USB InterfaceDrawer connection Printer 1 Cable Drawer connection Printer Cable DrawerAppendix Appendix C Special Modes Test PrintingExample of contents of HEX dump test printing HEX DumpSetting up the Printer Setup group items Setup items Memory switch Power on Status Disable EnableSetup Items Memory Switch setup itemsSerial Interface Condition setup items Other setup items Address your comments and inquiries on this manual to