Device errors
One of the following messages is displayed if an device errors in the scanner. If one of the following error messages is displayed, turn the power off and then on again. If the same message is displayed again, contact your service representative.
O p t i c a l | A l a r m |
| |
H e a t e r A l a r m | |
|
|
M e c h a n i c a l | A l a r m |
F u s e A l a r m – L a m p
F u s e A l a r m – H e a t e r
F u s e | A l | a r m | – | F B M o t o r |
|
|
|
|
|
F u s e | A l | a r m | – | A D F M o t o r |
Operation status messages
Operation status is displayed as shown by the following messages:
W a r m i n g – u p N o w ! !
The power is on.
N o w R e a d i n g !
Reading is in progress.
P l e a s e c l e a n – u p ! !
The glass plate is dirty. Clean it. In addition, clean the mirror as explained in Section 5.3.4.
P l e a s e c l e a n P i c k – r o l l e r
The pick roller is dirty. Clean it as explained in Section 5.3.2.
A D F L G |
|
|
|
|
| 4 | 0 0 H |
|
|
| |||||
|
|
| |||||
| R e a d y |
| |||||
The scanner is ready for operation in the manual mode.
Press the start button to start the read operation.
S c a n n e r R e a d y
The scanner is ready for operation.
2 – 12
⎫
⎪
⎬M3097E+
⎪
⎭
⎫
⎪
⎬M3097G+
⎪
⎭