Fujitsu M3097E+, M3097G+ manual Installation and Connections, Precautions

Page 22

CHAPTER 3 INSTALLATION AND CONNECTIONS

3.1Precautions

3.2Removing the Carrier Fixing Bracket

3.3Connections

3.4Mounting the Stacker

This chapter explains how to install and connect the image scanner.

3.1 Precautions

Do not install the image scanner in the following places and environ- ments. See the appendix A.1 “Installation Specifications” for the information such as size of installation space.

Place the scanner away from electrical noise sources and strong magnetic fields. If the image scanner is used near an air conditioner, copying machine, or TV set, the scanner may operate incorrectly.

Keep the scanner out of the sun and away from heaters. These environments may shorten scanner life or cause hardware failures.

Do not install the scanner in a humid, dusty, or damp places. These enviroments may shorten scaner life or cause hardware fail- ures. Do not place the image scanner where liquid spills may occur. Place it on a flat and even surface.

Do not install the scanner in a place where vibrations may occur. This environment may cause hardware failures or may cause the scanner to operate incorrectly.

Be aware of static electricity. If static electricity is generated, the scanner may operate incorrectly. Be sure that the flooring and the desk are made of materials that do not generate static electricity.

3 – 1

Image 22
Contents Image Scanner OPERATOR’S Guide Revision Record Important Note to Users Contents Appendix Figures Tables Preface Differences between the M3097E+ and the M3097G+This page is intentionally left blank Components Checking the ComponentsPart Names and Functions Exterior view of image scannerFunctions of each part Operator Panel Functions M3097E+ operator panelReady for reading indicator Green M3097E+ IndicatorsPower indicator Green Read reading in progress indicator Green M3097G+F a Liquid crystal display screenAutomatic document feeder ADF button Size buttonResolution button Density buttonLandscape button Halftone buttonMode 2 button Mode 1 buttonDocument button Messages Error messages temporary errors P e r E m p t yDevice errors Operation status messagesInstallation and Connections Precautions× × Removing the Carrier Fixing BracketConnections Page Mounting the Stacker This page is intentionally left blank Turning on the Power OperationsReading a Document in Flatbed Mode Reading a standard-size documentFlatbed reading Reading a page from a thick bookReading a document larger than the document board Removing the document coverReading Documents in ADF Mode ADF paper chute setting Top For portrait mode Or less Loading the document Maintenance Removing Jammed DocumentsCleaning Cleaning the ADF Cleaning the coupled feed roller Cleaning the mirrorT i c a l Alarm Replacing the Lamp UnitLamp unit removal Lamp unit replacement Inserting the glass Scsi Address Setting M3097G+ S I I DReplacing the pad Removing the padDocument counter display and reset Setup Mode Paper Count ResetThis page is intentionally left blank Chapter Troubleshooting Check itemsADF Table A.1 Installation specifications Installation SpecificationsAppendix External Dimensions Figure A.1 External dimensionsPage Page Japan Fujitsu Limited