Fujitsu M3097E+, M3097G+ manual Maintenance, Removing Jammed Documents

Page 36

CHAPTER 5 MAINTENANCE

5.1Removing Jammed Documents

5.2Notes on Daily Use

5.3Cleaning

5.4Replacing the Lamp Unit

5.5SCSI Address Setting (M3097G+)

5.6Replacing the Pad

5.7Document counter display and reset

This section explains how to remove jammed documents, and provides notes on daily use and cleaning.

If "Please clean-up!!" is displayed on the operator panel during the read operation, clean the mirror as explained in Section 5.3.4.

If "Please clean Pick-roller" is displayed, clean the pick roller as explained in Section 5.3.2.

5.1Removing Jammed Documents

If documents jam while being fed by the ADF, remove the jammed documents as follows:

1Remove the documents from the ADF paper chute.

2Pulling up the ADF lever, open the automatic document feeder.

3Remove the jammed documents.

4Close the ADF to the ADF lever.

ADF lever

Automatic document feeder (ADF)

Figure 5.1 Removing jammed documents

5 – 1

Image 36

Contents Image Scanner OPERATOR’S Guide Revision Record Important Note to Users Contents Appendix Figures Tables Preface Differences between the M3097E+ and the M3097G+This page is intentionally left blank Components Checking the ComponentsPart Names and Functions Exterior view of image scannerFunctions of each part Operator Panel Functions M3097E+ operator panelIndicators Power indicator GreenReady for reading indicator Green M3097E+ Read reading in progress indicator Green M3097G+F a Liquid crystal display screenAutomatic document feeder ADF button Size buttonResolution button Density buttonLandscape button Halftone buttonMode 1 button Mode 2 buttonDocument button Messages Error messages temporary errors P e r E m p t yDevice errors Operation status messagesInstallation and Connections Precautions× × Removing the Carrier Fixing BracketConnections Page Mounting the Stacker This page is intentionally left blank Turning on the Power OperationsReading a Document in Flatbed Mode Reading a standard-size documentFlatbed reading Reading a page from a thick bookReading a document larger than the document board Removing the document coverReading Documents in ADF Mode ADF paper chute setting Top For portrait mode Or less Loading the document Maintenance Removing Jammed DocumentsCleaning Cleaning the ADF Cleaning the coupled feed roller Cleaning the mirrorT i c a l Alarm Replacing the Lamp UnitLamp unit removal Lamp unit replacement Inserting the glass Scsi Address Setting M3097G+ S I I DReplacing the pad Removing the padDocument counter display and reset Setup Mode Paper Count ResetThis page is intentionally left blank Chapter Troubleshooting Check itemsADF Installation Specifications Table A.1 Installation specificationsAppendix External Dimensions Figure A.1 External dimensionsPage Page Japan Fujitsu Limited