Fujitsu M3097E+, M3097G+ manual Operations, Turning on the Power

Page 28

CHAPTER 4 OPERATIONS

4.1Turning on the Power

4.2Reading a Document in Flatbed Mode

4.3Reading Documents in ADF Mode

Documents can be read in the flatbed mode or automatic document feeder (ADF) mode. In the flat-bed mode, each document is placed on the document bed and is read one by one. In ADF mode, documents are fed and read automatically.

This section explains how to turn on the power and how to read documents.

4.1 Turning on the Power

This section explains how to turn on the power.

Press the power switch. When the power is turned on, the power indicator is lit.

Power indicator

Power switch

Press the power switch again to turn off the power.

4 – 1

Image 28

Contents Image Scanner OPERATOR’S Guide Revision Record Important Note to Users Contents Appendix Figures Tables Preface Differences between the M3097E+ and the M3097G+This page is intentionally left blank Components Checking the ComponentsPart Names and Functions Exterior view of image scannerFunctions of each part Operator Panel Functions M3097E+ operator panelIndicators Power indicator GreenReady for reading indicator Green M3097E+ Read reading in progress indicator Green M3097G+F a Liquid crystal display screenAutomatic document feeder ADF button Size buttonResolution button Density buttonLandscape button Halftone buttonMode 2 button Mode 1 buttonDocument button Messages Error messages temporary errors P e r E m p t yDevice errors Operation status messagesInstallation and Connections Precautions× × Removing the Carrier Fixing BracketConnections Page Mounting the Stacker This page is intentionally left blank Turning on the Power OperationsReading a Document in Flatbed Mode Reading a standard-size documentFlatbed reading Reading a page from a thick bookReading a document larger than the document board Removing the document coverReading Documents in ADF Mode ADF paper chute setting Top For portrait mode Or less Loading the document Maintenance Removing Jammed DocumentsCleaning Cleaning the ADF Cleaning the coupled feed roller Cleaning the mirrorT i c a l Alarm Replacing the Lamp UnitLamp unit removal Lamp unit replacement Inserting the glass Scsi Address Setting M3097G+ S I I DReplacing the pad Removing the padDocument counter display and reset Setup Mode Paper Count ResetThis page is intentionally left blank Chapter Troubleshooting Check itemsADF Table A.1 Installation specifications Installation SpecificationsAppendix External Dimensions Figure A.1 External dimensionsPage Page Japan Fujitsu Limited