Fujitsu M3097G+, M3097E+ manual Cleaning

Page 37

5.2Notes on Daily Use

IMPORTANT

Note the following points on daily use:

The image scanner requires one to three minutes to warm up after the power has been turned on. During this time, the message “Warming-up Now!!” is displayed on the screen.

Do not look directly at the light source during the read operation. Keep the document cover in place.

See Section 5.3 “Cleaning”, to clean the document cover, document holding pad, document bed, and the automatic document feeder.

Especially, clean the ADF periodically. For cleaning cycle, see Section 5.3.2 “Cleaning the ADF”.

5.3Cleaning

This section explains how to clean the image scanner.

5.3.1Cleaning the document cover, document holding pad, and document bed

NOTICE

Use a dry cloth or a cloth with a neutral cleanser or ethyl alcohol to remove dirt from the document cover, document holding pad, and document bed.

Do not use organic solvents such as a thinner.

Make sure that no liquid enters the scanner from the edges of the document bed glass.

Document cover

Document holding pad

Cloth

Document bed

Neutral cleanser or ethyl alcohol

Thinner

Figure 5.2 Cleaning the document cover, document holding pad, and document bed

5 – 2

Image 37
Contents Image Scanner OPERATOR’S Guide Revision Record Important Note to Users Contents Appendix Figures Tables Differences between the M3097E+ and the M3097G+ PrefaceThis page is intentionally left blank Checking the Components ComponentsExterior view of image scanner Part Names and FunctionsFunctions of each part M3097E+ operator panel Operator Panel FunctionsPower indicator Green IndicatorsReady for reading indicator Green M3097E+ Read reading in progress indicator Green M3097G+Liquid crystal display screen F aSize button Automatic document feeder ADF buttonDensity button Resolution buttonHalftone button Landscape buttonMode 2 button Mode 1 buttonDocument button P e r E m p t y Messages Error messages temporary errorsOperation status messages Device errorsPrecautions Installation and ConnectionsRemoving the Carrier Fixing Bracket × ×Connections Page Mounting the Stacker This page is intentionally left blank Operations Turning on the PowerReading a standard-size document Reading a Document in Flatbed ModeReading a page from a thick book Flatbed readingRemoving the document cover Reading a document larger than the document boardReading Documents in ADF Mode ADF paper chute setting Top For portrait mode Or less Loading the document Removing Jammed Documents MaintenanceCleaning Cleaning the ADF Cleaning the mirror Cleaning the coupled feed rollerReplacing the Lamp Unit T i c a l AlarmLamp unit removal Lamp unit replacement Inserting the glass S I I D Scsi Address Setting M3097G+Removing the pad Replacing the padSetup Mode Paper Count Reset Document counter display and resetThis page is intentionally left blank Check items Chapter TroubleshootingADF Table A.1 Installation specifications Installation SpecificationsAppendix Figure A.1 External dimensions External DimensionsPage Page Japan Fujitsu Limited