Fujitsu M3097E+, M3097G+ manual Flatbed reading, Reading a page from a thick book

Page 30

Reference mark

Document

Document bed

Operator panel

Figure 4.1 Flatbed reading

Document cover

Landscape mode

side

 

Long

3

 

Portrait mode

side

 

Short

3

 

Document bed

Document

4.2.2Reading a page from a thick book

To read a page from a thick book, remember the following points:

1Do not close the document cover forcibly. Keep the cover open for reading.

2Any document parts that are not in contact with the glass will not be read correctly.

3Do not move the document during the read operation.

4 – 3

Image 30
Contents Image Scanner OPERATOR’S Guide Revision Record Important Note to Users Contents Appendix Figures Tables Preface Differences between the M3097E+ and the M3097G+This page is intentionally left blank Components Checking the ComponentsPart Names and Functions Exterior view of image scannerFunctions of each part Operator Panel Functions M3097E+ operator panelReady for reading indicator Green M3097E+ IndicatorsPower indicator Green Read reading in progress indicator Green M3097G+F a Liquid crystal display screenAutomatic document feeder ADF button Size buttonResolution button Density buttonLandscape button Halftone buttonMode 1 button Mode 2 buttonDocument button Messages Error messages temporary errors P e r E m p t yDevice errors Operation status messagesInstallation and Connections Precautions× × Removing the Carrier Fixing BracketConnections Page Mounting the Stacker This page is intentionally left blank Turning on the Power OperationsReading a Document in Flatbed Mode Reading a standard-size documentFlatbed reading Reading a page from a thick bookReading a document larger than the document board Removing the document coverReading Documents in ADF Mode ADF paper chute setting Top For portrait mode Or less Loading the document Maintenance Removing Jammed DocumentsCleaning Cleaning the ADF Cleaning the coupled feed roller Cleaning the mirrorT i c a l Alarm Replacing the Lamp UnitLamp unit removal Lamp unit replacement Inserting the glass Scsi Address Setting M3097G+ S I I DReplacing the pad Removing the padDocument counter display and reset Setup Mode Paper Count ResetThis page is intentionally left blank Chapter Troubleshooting Check itemsADF Installation Specifications Table A.1 Installation specificationsAppendix External Dimensions Figure A.1 External dimensionsPage Page Japan Fujitsu Limited