Fujitsu M3097E+, M3097G+ manual Chapter Troubleshooting, Check items

CHAPTER 6	TROUBLESHOOTING
	If a problem occurs, use Table 6.1 to resolve the problem.
	Table 6.1 Check items
Problem	Possible cause	Response
No power	The power switch was not	Press the power switch.
	turned on.
	The power cable was not	Connect the power cable correctly.
	connected correctly.
	——————————	Turn off the power once and make an
		attempt to turn on the power again. If the
		power is not turned on, contact your
		Fujitsu service representative.
Read operation	The ready indicator was not	If the ready indicator is on, press the start
does not start.	on (in the manual mode for	button.
	M3097E+).
	The documents were not	Insert the first a few pages into the slot.
	placed on the ADF correctly.
	The ADF was not closed	Make sure that the ADF is closed com-
	completely.	pletely.
	The interface cables were not	Connect the interface cables correctly.
	connected correctly.
Pictures and	Halftone processing was not	Select a halftone mode from the host
photographs are	selected.	system, or use the halftone button if
not read cor-		M3097E+ is used.
rectly.
	The document bed, docu-	Clean the dirty parts as explained in
	ment holding pad, or inside	Section 5.3, “Cleaning.”
	ADF is dirty.
Characters and	Simple binarization was not	Select a binarization mode from the host
lines are not	done.	computer, or use the halftone button if
read correctly.		M3097E+ is used.
	The document bed, docu-	Clean the dirty parts as explained in
	ment holding pad, or the	Section 5.3, “Cleaning.”
	inside of the ADF is dirty.
Image is dis-	The document was moved	Keep the document cover closed during
torted or un-	during the read operation.	reading so that the document will not be
clear.		moved.
	The document was not in	Adjust the document so that it is in
	contact with the glass.	contact with the glass.

6 – 1