Fujitsu M3097G+, M3097E+ manual Adf

Table 6.1 Check items (continued)

Problem	Possible cause	Response
The lamp does	The interface cables were not	Connect the interface cables correctly.
not light (ready)	connected correctly.
while the power
	The terminator was not	Connect the terminator.
indicator blinks.
	connected.
The check	The carrier fixing bracket	Remove the carrier fixing bracket as
indicator is on.	was not removed.	explained in Section 3.2, “Removing the
		Carrier Fixing Bracket.”
	——————————	Turn the power off then on again. If the
		check indicator turns on again, contact the
		sales person in charge or a Fujitsu service
		representative.
"Please clean-	The mirror is dirty.	Clean the mirror as explained in Sec-
up!!" is dis-		tion 5.3.4.
played on the
operator panel
during the read
operation.
"Please clean	The pick roller is dirty.	When the power is turned off, the mes-
Pick-roller" is		sage is cleared.
displayed on the		Even if the message is displayed, the read
operator panel		operation can be continued. Clean the
during the read		pick roller after the read operation.
operation in the		(See Section 5.3.2.)
automatic
	The unallowable document	If a document not meeting the scanner
document
	was read in the automatic	specifications is read in the automatic
feeder.
	document feeder.	document feeder, the document is not fed
	(See Section 4.3.)	smoothly and an error message may be
		displayed.
		Read the document in the flat bed station.
Paper double	Pad is dirty.	Clean the Pad. (See Section 5.3.2)
feed
Miss pick	Pick rollers are dirty.	Clean the Pick rollers. (See Section 5.3.2)
Paper jam	Some foreign particles are in	Clean the ADF (See Section 5.3.2) or
	ADF	remove any foreign particles.

6 – 2