Cisco Systems 159330, 124792, 124778 manual Install GMT Fuse Connections

Chapter 2 System Installation

2.5.1 Install GMT Fuse Connections

Table 2-7 Recommended Wire Sizes (continued)

Wire Gauge Stranded	Applications
14 AWG (2.5mm²)	10A GMT Fuses
14 AWG (2.5mm²)	15A GMT Fuses

2.5.1 Install GMT Fuse Connections

Load connections to the GMT fuse panel are made using spring loaded terminals that do not require the use of connection lugs.

Step 1 Locate the GMT fuse connections by removing the controller faceplate (Figure 2-19) and sliding the GMT drawer out (Figure 2-22).

Figure 2-22 GMT Drawer

Step 2 Route the GMT load-and-return cabling from the rear of the system shelf (leaving enough of a service loop to allow the drawer to slide out) through the fuse panel channel and secure using the supplied tie-downs.

Step 3 Connect the wires to the appropriate terminal by using a flat screwdriver to open the terminal (Figure 2-23) and inserting the appropriate cable into the spring-loaded terminals. Terminals correspond to fuses: Side A (1-5) and Side B (1-5) from left to right (viewed from the front of the system).

Cisco AC/DC Power System User Guide, R1.0

May 2006 2-25