Fujitsu Siemens Computers Point 1600 manual Assembling and Installing Connectivity Peripherals

Page 17

Chapter 2

Assembling and Installing Connectivity Peripherals

This chapter describes the assembly and installation of connectivity peripherals.

Portable Port Expander

The portable port expander can be used alone with the pen tablet or it can be installed in the cradle module as a component in other connectivity peripheral assemblies.

The portable port expander is equipped with a latch mechanism and spacer to allow it to be attached directly to the pen tablet. For details on attaching the portable port expander to the pen tablet and connecting peripheral devices, refer to the Connectivity Peripherals User’s Guide.

Removing the Latch and Spacer (For Installation in Cradle Module Only)

The portable port expander is shipped with two extra screws that are used if the portable port expander is installed in the cradle module as a component in another connectivity peripheral assembly. If you plan to install the portable port expander in the cradle module, you must first remove the latch and spacer. To do so, remove the screws (called out in Figure 2-1) that fasten the latch and spacer to the portable port expander. (Save the latch, spacer, and screws in case they are needed later.) Once the latch is removed, the portable port expander can be installed in the cradle module.

Spacer

Screws

Latch

Latch Detail:

Latch Handle

Locked Position

Unlocked Position

Figure 2-1. Portable Port Expander Latch

2-1

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Point Page Point Page Canadian DOC Compliance FCC NoticePage Table of Contents Page Organization About This GuideViii About This Guide Connectivity Peripheral Model Numbers Introduction to Connectivity PeripheralsConnectors on Connectivity Peripherals Portable Port Expander Cradle ModuleHigh-Usage Cradle Port ReplicatorHigh-Connectivity Cradle Charge-Only Cradle Wall-Mount CradleAssembling and Installing Connectivity Peripherals Bottom View, Portable Port Expander Portable Port Expander ConnectorsAssembling the Port Replicator Attaching the Feet Port Replicator Back View Bottom View, Port Replicator Port Replicator ConnectorsUsing the Folding Desk Stand Assembling the High-Usage Cradle High-Usage Cradle Assembly High-Usage Cradle Bottom View High-Usage Cradle Connectors Installing the High-Usage Cradle Fastening Cradle Module to Desktop Assembling the High-Connectivity Cradle 10. High-Connectivity Cradle Assembly 11. High-Connectivity Cradle Bottom View Installing the High-Connectivity Cradle High-Connectivity Cradle Connectors Required Tools and Hardware Installing the Wall-Mount CradleAssembling and Installing Connectivity Peripherals 12. Wall-Mount Cradle Mounting Plate 13. Coiling DC Supply Cable 15. Wall-Mount Cradle Exploded View Push Tighten Tighten Push 19. Fastening Cradle Module Left Side 21. Checking Cradle Module Alignment Testing the Wall-Mount Cradle After Installation Wall-Mount Cradle Connectors 23. Charge-Only Cradle Installing the Charge-Only Cradle24. Status Lights on the Pen Tablet Confirming External Power Is SuppliedAssembling and Installing Connectivity Peripherals Index Page Page 58-0627-00A
Top Page Image Contents