Fujitsu Siemens Computers Point 1600, Point 500 manual Assembling the Port Replicator

Page 19

Assembling the Port Replicator

The port replicator is assembled using a cradle module and a portable port expander. The process of assembling the port replicator is outlined in the following:

•Install the portable port expander in the cradle module.

•Attach the rubber feet to the cradle module.

•Attach the wire catch to the cradle module.

(Required if using the port replicator with the folding desk stand.)

Detailed procedures for these tasks are given in this section. Before you begin, the latch and spacer provided with the portable port expander must be removed. See “Removing the Latch and Spacer (For Installation in Cradle Module Only)” on page 2-1 for details.

Note that the following hardware is included with the cradle module and is used when assembling the port replicator:

•Four rubber feet with four mounting screws

•Wire catch

•Cover label (not used in this assembly)

•Two tube keys for use with the tubular lock (locking versions only)

Assembling the Port Replicator

2-3

Image 19

Contents Point Page Point Page Canadian DOC Compliance FCC NoticePage Table of Contents Page Organization About This GuideViii About This Guide Connectivity Peripheral Model Numbers Introduction to Connectivity PeripheralsConnectors on Connectivity Peripherals Portable Port Expander Cradle ModuleHigh-Usage Cradle Port ReplicatorHigh-Connectivity Cradle Charge-Only Cradle Wall-Mount CradleAssembling and Installing Connectivity Peripherals Bottom View, Portable Port Expander Portable Port Expander ConnectorsAssembling the Port Replicator Attaching the Feet Port Replicator Back View Bottom View, Port Replicator Port Replicator ConnectorsUsing the Folding Desk Stand Assembling the High-Usage Cradle High-Usage Cradle Assembly High-Usage Cradle Bottom View High-Usage Cradle Connectors Installing the High-Usage Cradle Fastening Cradle Module to Desktop Assembling the High-Connectivity Cradle 10. High-Connectivity Cradle Assembly 11. High-Connectivity Cradle Bottom View Installing the High-Connectivity Cradle High-Connectivity Cradle Connectors Required Tools and Hardware Installing the Wall-Mount CradleAssembling and Installing Connectivity Peripherals 12. Wall-Mount Cradle Mounting Plate 13. Coiling DC Supply Cable 15. Wall-Mount Cradle Exploded View Push Tighten Tighten Push 19. Fastening Cradle Module Left Side 21. Checking Cradle Module Alignment Testing the Wall-Mount Cradle After Installation Wall-Mount Cradle Connectors 23. Charge-Only Cradle Installing the Charge-Only Cradle24. Status Lights on the Pen Tablet Confirming External Power Is SuppliedAssembling and Installing Connectivity Peripherals Index Page Page 58-0627-00A