Fujitsu Siemens Computers Point 500, Point 1600 manual High-Connectivity Cradle Bottom View

Page 32

To install the AC adapter in the cradle base,

1.Turn the cradle base upside down.

2.Detach one end of the Velcro strap and insert the AC adapter into the cavity in the bottom of the cradle base as shown in Figure 2-11.

3.Reattach the velcro strap to secure the AC adapter.

4.Attach the DC power cable from the AC adapter to the DC input connector on the cradle module.

5.Coil the DC supply cable of the AC adapter into “figure-eight” loops as shown in Figure 2-11 and tie the coiled cable using the tie wrap provided. Ensure that there is enough slack in the cable to allow the cradle module to pivot to the fully tilted position.

The cradle is now ready for installation at the work site.

Cutouts		Serial Port A		Floppy Disk Port
Cutouts				Cutouts
(for cable routing)	Keyboard	Serial Port B	Mouse Port	(for cable routing)
	Port

DC Input

Power Port

Mouse

Port

Cutouts (for cable routing)

Velcro

Strap

Parallel Port

Video Port

Cutouts (for cable routing)

(Tie excess cable here.)

Mounting Holes

AC Adapter

AC Power Cable

Figure 2-11. High-Connectivity Cradle Bottom View

2-16	Assembling and Installing Connectivity Peripherals

Image 32

Contents Point Page Point Page FCC Notice Canadian DOC CompliancePage Table of Contents Page About This Guide OrganizationViii About This Guide Introduction to Connectivity Peripherals Connectivity Peripheral Model NumbersConnectors on Connectivity Peripherals Cradle Module Portable Port ExpanderPort Replicator High-Usage CradleHigh-Connectivity Cradle Wall-Mount Cradle Charge-Only CradleAssembling and Installing Connectivity Peripherals Portable Port Expander Connectors Bottom View, Portable Port ExpanderAssembling the Port Replicator Attaching the Feet Port Replicator Back View Port Replicator Connectors Bottom View, Port ReplicatorUsing the Folding Desk Stand Assembling the High-Usage Cradle High-Usage Cradle Assembly High-Usage Cradle Bottom View High-Usage Cradle Connectors Installing the High-Usage Cradle Fastening Cradle Module to Desktop Assembling the High-Connectivity Cradle 10. High-Connectivity Cradle Assembly 11. High-Connectivity Cradle Bottom View Installing the High-Connectivity Cradle High-Connectivity Cradle Connectors Installing the Wall-Mount Cradle Required Tools and HardwareAssembling and Installing Connectivity Peripherals 12. Wall-Mount Cradle Mounting Plate 13. Coiling DC Supply Cable 15. Wall-Mount Cradle Exploded View Push Tighten Tighten Push 19. Fastening Cradle Module Left Side 21. Checking Cradle Module Alignment Testing the Wall-Mount Cradle After Installation Wall-Mount Cradle Connectors Installing the Charge-Only Cradle 23. Charge-Only CradleConfirming External Power Is Supplied 24. Status Lights on the Pen TabletAssembling and Installing Connectivity Peripherals Index Page Page 58-0627-00A