Fujitsu Siemens Computers Point 500, Point 1600 manual Push Tighten

Page 40

11.Connect the AC power cable (from the junction box) to the AC adapter. To do so, bring the keyboard tray assembly close to the cradle plate that is already mounted on the wall.

12.Attach the keyboard tray assembly to the mounting plate as shown in Figure 2-16, Figure 2-17, and Figure 2-18.Use the six screws (size # 8) provided with the wall-mount cradle. (Figure 2-15 on page 2-23also shows the location of these screws.) Ensure that the cables are not pinched between the keyboard tray assembly and the cradle plate. (Note that the flanges on the mounting plate must go inside the keyboard tray assembly housing.)

When tightening the screws, ensure that the keyboard tray assembly is properly aligned with the mounting plate. To do so, push the front of the keyboard tray assembly toward the wall while you tighten the screws as shown in Figure 2-16 and Figure 2-17.

Push	Tighten

Figure 2-16. Attaching Keyboard Tray Assembly to Mounting Plate (Right Side)

2-24	Assembling and Installing Connectivity Peripherals

Image 40

Contents Point Page Point Page FCC Notice Canadian DOC CompliancePage Table of Contents Page About This Guide OrganizationViii About This Guide Introduction to Connectivity Peripherals Connectivity Peripheral Model NumbersConnectors on Connectivity Peripherals Cradle Module Portable Port ExpanderPort Replicator High-Usage CradleHigh-Connectivity Cradle Wall-Mount Cradle Charge-Only CradleAssembling and Installing Connectivity Peripherals Portable Port Expander Connectors Bottom View, Portable Port ExpanderAssembling the Port Replicator Attaching the Feet Port Replicator Back View Port Replicator Connectors Bottom View, Port ReplicatorUsing the Folding Desk Stand Assembling the High-Usage Cradle High-Usage Cradle Assembly High-Usage Cradle Bottom View High-Usage Cradle Connectors Installing the High-Usage Cradle Fastening Cradle Module to Desktop Assembling the High-Connectivity Cradle 10. High-Connectivity Cradle Assembly 11. High-Connectivity Cradle Bottom View Installing the High-Connectivity Cradle High-Connectivity Cradle Connectors Installing the Wall-Mount Cradle Required Tools and HardwareAssembling and Installing Connectivity Peripherals 12. Wall-Mount Cradle Mounting Plate 13. Coiling DC Supply Cable 15. Wall-Mount Cradle Exploded View Push Tighten Tighten Push 19. Fastening Cradle Module Left Side 21. Checking Cradle Module Alignment Testing the Wall-Mount Cradle After Installation Wall-Mount Cradle Connectors Installing the Charge-Only Cradle 23. Charge-Only CradleConfirming External Power Is Supplied 24. Status Lights on the Pen TabletAssembling and Installing Connectivity Peripherals Index Page Page 58-0627-00A