Fujitsu Siemens Computers Point 1600, Point 500 manual Checking Cradle Module Alignment

Page 43

15.Apply the cover label provided with the cradle module to the inside of the cradle module as shown in Figure 2-15 on page 2-23. (This label covers access holes in the cradle module that are not used in this assembly.)

16.Ensure that the cradle module is properly aligned as shown in Figure 2-21. There should be no gap between the cradle module and the mounting plate.

No Gap

No Gap

Figure 2-21. Checking Cradle Module Alignment

Installing the Wall-Mount Cradle

2-27

Image 43

Contents Point Page Point Page Canadian DOC Compliance FCC NoticePage Table of Contents Page Organization About This GuideViii About This Guide Connectivity Peripheral Model Numbers Introduction to Connectivity PeripheralsConnectors on Connectivity Peripherals Portable Port Expander Cradle ModuleHigh-Usage Cradle Port ReplicatorHigh-Connectivity Cradle Charge-Only Cradle Wall-Mount CradleAssembling and Installing Connectivity Peripherals Bottom View, Portable Port Expander Portable Port Expander ConnectorsAssembling the Port Replicator Attaching the Feet Port Replicator Back View Bottom View, Port Replicator Port Replicator ConnectorsUsing the Folding Desk Stand Assembling the High-Usage Cradle High-Usage Cradle Assembly High-Usage Cradle Bottom View High-Usage Cradle Connectors Installing the High-Usage Cradle Fastening Cradle Module to Desktop Assembling the High-Connectivity Cradle 10. High-Connectivity Cradle Assembly 11. High-Connectivity Cradle Bottom View Installing the High-Connectivity Cradle High-Connectivity Cradle Connectors Required Tools and Hardware Installing the Wall-Mount CradleAssembling and Installing Connectivity Peripherals 12. Wall-Mount Cradle Mounting Plate 13. Coiling DC Supply Cable 15. Wall-Mount Cradle Exploded View Push Tighten Tighten Push 19. Fastening Cradle Module Left Side 21. Checking Cradle Module Alignment Testing the Wall-Mount Cradle After Installation Wall-Mount Cradle Connectors 23. Charge-Only Cradle Installing the Charge-Only Cradle24. Status Lights on the Pen Tablet Confirming External Power Is SuppliedAssembling and Installing Connectivity Peripherals Index Page Page 58-0627-00A