Fujitsu Siemens Computers Point 500, Point 1600 manual Installing the High-Usage Cradle

Page 28

Installing the High-Usage Cradle

To install the high-usage cradle at the work site,

1.Determine the appropriate desktop location. Account for:

•Distance to an AC outlet.

•Distance from desk edge to allow for easy access and positioning of a keyboard and mouse pad.

•Desk or table legs so it is easy to sit in front of and use the system.

•Routing the AC adapter power cord over the back edge of the desk, a notch in the desktop, or through a hole drilled in the desktop. Ensure that the wire will not get entangled in the user’s feet or in the feet of those who walk by the desk.

2.Turn the high-usage cradle upside-down.

3.Attach your keyboard and mouse, if used, to the keyboard and mouse ports on the bottom of the high-usage cradle module.

4.Route the cables for the keyboard and mouse through one of the following paths:

•Through the cutouts provided in the front and sides of the cradle base called out in Figure 2-8.

•Out the back of the cradle base via the channel in the middle.

5.Turn the high-usage cradle upside-up and place it at the desired location. (Be sure the cables are still routed properly and are not pinched under the cradle base.)

6.Check for free play of the cradle module by adjusting the viewing angle. To do so, loosen the adjusting knob and rock the cradle module forward and backward. After you verify that the wires do not bind or restrict use of the high-connectivity cradle, tighten the knob.

7.Ensure that the high-usage cradle is in the desired location.

2-12

Assembling and Installing Connectivity Peripherals

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Point Page Point Page FCC Notice Canadian DOC CompliancePage Table of Contents Page About This Guide OrganizationViii About This Guide Introduction to Connectivity Peripherals Connectivity Peripheral Model NumbersConnectors on Connectivity Peripherals Cradle Module Portable Port ExpanderPort Replicator High-Usage CradleHigh-Connectivity Cradle Wall-Mount Cradle Charge-Only CradleAssembling and Installing Connectivity Peripherals Portable Port Expander Connectors Bottom View, Portable Port ExpanderAssembling the Port Replicator Attaching the Feet Port Replicator Back View Port Replicator Connectors Bottom View, Port ReplicatorUsing the Folding Desk Stand Assembling the High-Usage Cradle High-Usage Cradle Assembly High-Usage Cradle Bottom View High-Usage Cradle Connectors Installing the High-Usage Cradle Fastening Cradle Module to Desktop Assembling the High-Connectivity Cradle 10. High-Connectivity Cradle Assembly 11. High-Connectivity Cradle Bottom View Installing the High-Connectivity Cradle High-Connectivity Cradle Connectors Installing the Wall-Mount Cradle Required Tools and HardwareAssembling and Installing Connectivity Peripherals 12. Wall-Mount Cradle Mounting Plate 13. Coiling DC Supply Cable 15. Wall-Mount Cradle Exploded View Push Tighten Tighten Push 19. Fastening Cradle Module Left Side 21. Checking Cradle Module Alignment Testing the Wall-Mount Cradle After Installation Wall-Mount Cradle Connectors Installing the Charge-Only Cradle 23. Charge-Only CradleConfirming External Power Is Supplied 24. Status Lights on the Pen TabletAssembling and Installing Connectivity Peripherals Index Page Page 58-0627-00A
Top Page Image Contents