Fujitsu Siemens Computers Point 1600, Point 500 manual Port Replicator Back View

replicator on the desk stand in one of three orientations: one landscape-mode and two portrait-mode positions.

Feet

Attach wire catch

here for portrait

orientation (left

side up).

Wire Catch

Feet

Attach wire catch here for portrait orientation (right side up).

Figure 2-4. Port Replicator (Back View)

To install the wire catch,

1.Determine which set of mounting holes is appropriate depending on how you intend to orient the pen tablet on the desk stand. Figure 2-4 shows the wire catch installed in the landscape-mode position. The mounting holes for both portrait-mode positions are also called out.

2.Insert one end of the wire catch into the round hole.

3.Insert the opposite end of the wire catch into the corresponding slotted hole. To do so, push the end of the wire catch inward until it can be inserted into the hole.

Note: Ensure that the wire catch is not installed backwards. When installed correctly, the wire catch hooks over the top of the desk stand.

Connectors

Figure 2-5shows the location of connectors on the port replicator. Note that the ability of the pen tablet to utilize these connectors is determined by BIOS settings. Ensure that the ports you intend to use are enabled and properly configured in the BIOS.

Assembling the Port Replicator 2-5