Fujitsu Siemens Computers Point 500, Point 1600 manual Assembling the High-Usage Cradle

Page 24

Assembling the High-Usage Cradle

The following outlines the process of assembling the high-usage cradle:

•Attach the cradle module to the cradle base.

•Install the AC adapter in the cradle base.

Detailed procedures for assembling the cradle module, cradle base, and AC adapter are given in this section. (Peripherals, such as the keyboard and mouse, are attached later when the cradle is installed at the work site.)

The following hardware, supplied with connectivity peripheral components, is used in this assembly. (Note that other hardware is supplied that is not used in this assembly.)

•Knob, spacer, nylon washer, star lock-washer, screw, and cover (included with cradle base)

•Cover label (included with cradle module)

•Two tube keys for use with the tubular lock (included with the locking version of the cradle module) To attach the cradle module to the cradle base,

1.Insert the cradle module into the cradle base, as shown in Figure 2-7. Note that this may be a snug fit. The cradle base is equipped with metal brackets, one at each end where the screws fasten the cradle module. A felt pad is glued onto each bracket. Ensure that the felt pads remain in position (between the cradle module and the bracket) as you insert the cradle module.

2.Line up the holes in the side of the cradle module with those in the cradle base.

2-8

Assembling and Installing Connectivity Peripherals

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Point Page Point Page FCC Notice Canadian DOC CompliancePage Table of Contents Page About This Guide OrganizationViii About This Guide Introduction to Connectivity Peripherals Connectivity Peripheral Model NumbersConnectors on Connectivity Peripherals Cradle Module Portable Port ExpanderPort Replicator High-Usage CradleHigh-Connectivity Cradle Wall-Mount Cradle Charge-Only CradleAssembling and Installing Connectivity Peripherals Portable Port Expander Connectors Bottom View, Portable Port ExpanderAssembling the Port Replicator Attaching the Feet Port Replicator Back View Port Replicator Connectors Bottom View, Port ReplicatorUsing the Folding Desk Stand Assembling the High-Usage Cradle High-Usage Cradle Assembly High-Usage Cradle Bottom View High-Usage Cradle Connectors Installing the High-Usage Cradle Fastening Cradle Module to Desktop Assembling the High-Connectivity Cradle 10. High-Connectivity Cradle Assembly 11. High-Connectivity Cradle Bottom View Installing the High-Connectivity Cradle High-Connectivity Cradle Connectors Installing the Wall-Mount Cradle Required Tools and HardwareAssembling and Installing Connectivity Peripherals 12. Wall-Mount Cradle Mounting Plate 13. Coiling DC Supply Cable 15. Wall-Mount Cradle Exploded View Push Tighten Tighten Push 19. Fastening Cradle Module Left Side 21. Checking Cradle Module Alignment Testing the Wall-Mount Cradle After Installation Wall-Mount Cradle Connectors Installing the Charge-Only Cradle 23. Charge-Only CradleConfirming External Power Is Supplied 24. Status Lights on the Pen TabletAssembling and Installing Connectivity Peripherals Index Page Page 58-0627-00A
Top Page Image Contents