Fujitsu Siemens Computers Point 1600, Point 500 manual Wall-Mount Cradle Mounting Plate

Page 37

Mounting Holes (To attach plate to wall.)

Mounting Holes (To attach plate to junction box.)

Mounting Holes (To attach plate to wall.)

Mounting Holes (To attach plate to junction box.)

Figure 2-12. Wall-Mount Cradle Mounting Plate

To install the wall-mount cradle,

1.Attach the mounting plate to the junction box. To do so, align the square hole in the mounting plate with the junction box and fasten the plate to the junction box. Use four screws with star-washers (not provided) to fasten the plate to the junction box. (The star-washers are required to break through the paint on the mounting plate and ensure that the plate is grounded to the electrical junction box.)

2.Attach the mounting plate to the wall. The bottom two round holes should be used so that the wall-mount cradle cannot be lifted up once installed. At least two of the four slotted holes should also be used and properly fastened to the wall according to local building codes.

3.Unplug the AC power cable from the AC adapter.

Installing the Wall-Mount Cradle

2-21

Image 37

Contents Point Page Point Page Canadian DOC Compliance FCC NoticePage Table of Contents Page Organization About This GuideViii About This Guide Connectivity Peripheral Model Numbers Introduction to Connectivity PeripheralsConnectors on Connectivity Peripherals Portable Port Expander Cradle ModuleHigh-Usage Cradle Port ReplicatorHigh-Connectivity Cradle Charge-Only Cradle Wall-Mount CradleAssembling and Installing Connectivity Peripherals Bottom View, Portable Port Expander Portable Port Expander ConnectorsAssembling the Port Replicator Attaching the Feet Port Replicator Back View Bottom View, Port Replicator Port Replicator ConnectorsUsing the Folding Desk Stand Assembling the High-Usage Cradle High-Usage Cradle Assembly High-Usage Cradle Bottom View High-Usage Cradle Connectors Installing the High-Usage Cradle Fastening Cradle Module to Desktop Assembling the High-Connectivity Cradle 10. High-Connectivity Cradle Assembly 11. High-Connectivity Cradle Bottom View Installing the High-Connectivity Cradle High-Connectivity Cradle Connectors Required Tools and Hardware Installing the Wall-Mount CradleAssembling and Installing Connectivity Peripherals 12. Wall-Mount Cradle Mounting Plate 13. Coiling DC Supply Cable 15. Wall-Mount Cradle Exploded View Push Tighten Tighten Push 19. Fastening Cradle Module Left Side 21. Checking Cradle Module Alignment Testing the Wall-Mount Cradle After Installation Wall-Mount Cradle Connectors 23. Charge-Only Cradle Installing the Charge-Only Cradle24. Status Lights on the Pen Tablet Confirming External Power Is SuppliedAssembling and Installing Connectivity Peripherals Index Page Page 58-0627-00A