Cisco Systems N55M4Q manual Where to Go Next

Page 35

Chapter 2 Switch Installation

Where to Go Next

restricted access location and users and service people who are authorized within the restricted access location are made aware of the hazard. A restricted access area can be accessed only through the use of a special tool, lock and key or other means of security. Statement 1072

Caution Category 5e and Category 6 cables can store high levels of static electricity. Always ground the cables to a suitable and safe earth ground before connecting them to the switch or other devices.

Where to Go Next

To change the switch settings, you can use the switch default configuration or use any of the management options described in the “Management Options”section.

 

 

Catalyst 3560-C and 2960-C Switch Hardware Installation Guide

 

 

 

 

 

 

OL-23803-02

 

 

2-35

 

 

 

 

 

Image 35
Contents Preparing for Installation Switch InstallationStatement Installation Guidelines Equipment That You Supply Powering the SwitchBox Contents Mounting the Switch Verifying Switch OperationDesk- or Shelf-Mounting On a Desk or Shelf without Mounting ScrewsDesk, Shelf, or Wall with Mounting Screws Installing the Mounting Screws on Top of a Desk or a Shelf Under the Desk- or Shelf-Mounting Mounting the Switch on Top of a Desk or ShelfDesk or shelf Screws Screw template Adhesive Desk or shelf Slides on this way Wall-Mounting77 in .49 cm 72 in .44 cm 46. 62 in .19 cm Switch Installing the Mounting Screws on the Wall Mounting Tray with Screws With a Mounting TraySwitch Mounting tray Sliding direction Desk Mounting Tray with a Magnet 10 Securing the Mounting Tray to the SwitchPlace the switch on the mounting tray. See Figure 13 Wall-Mounting with a Magnet A Rack Attaching Brackets to the Switch15 Attaching the 23-inch Brackets for Rack-Mounting Mounting the Switch in a RackOn a DIN Rail Attaching the DIN-Mount Tray to the Switch18 Securing the DIN-Mount Tray to the Switch Mounting the Switch on a DIN Rail19 Mounting the Switch on a DIN Rail Removing the Switch from a DIN Rail 21 Reset Cover on the Catalyst 2960CPD-8PT-L Switch Installing a Cover for the Reset Button Optional23 Inserting the Retainer through the Lanced Loop Installing the Power Cord Retainer OptionalSlide the retainer through the first latch. See Figure 26 Sleeve Around the Power Cord Washer Installing the Cable Guard Optional29 Attaching the Cable Guard to the Switch 31 Attaching the Cables to the Switch Installing SFP Modules After Installing the SwitchRemoving SFP Modules 34 Installing an SFP ModuleConnecting to the 10/100 and 10/100/1000 Ports Connecting Devices to the Ethernet PortsDevice Crossover Cable Connecting to the PoE PortsWhere to Go Next OL-23803-02
Related manuals
Manual 168 pages 60.68 Kb