Cisco Systems OL-23421-02 manual Installing the Switch Module in the CGR 2010 Router

Page 20

Chapter 2 Installation

Installation

Step 4 Grasp the handles and carefully slide the module into the card guide, then push with both hands until the module is flush against the router chassis (see Figure 2-3).

Figure 2-3 Installing the Switch Module in the CGR 2010 Router

237927

Step 5 Tighten the screws:

a. Tighten the lower flathead screw to the bottom center hole. b. Tighten the second panhead screw to the top center hole.

Step 6 Tighten the three captive screws on the front of the switch module:

a.Tighten the captive screw on the lower left of the module.

b.Tighten the single captive screw on the right side of the module.

c.Finally, tighten the captive screw on the upper left of the module.

The switch module is now successfully installed in the router (see Figure 2-4).

Cisco Connected Grid Ethernet Switch Module Interface Card Getting Started Guide

2-4	OL-23421-02

Image 20

Contents Cisco Systems, Inc Page N T E N T S Other Management Options Document Conventions PrefacePurpose Obtaining Documentation and Submitting a Service Request Related PublicationsSwitch Models Mode DescriptionProduct Overview GRWIC-D-ES-2S-8PCPorts Port LocationsPort Labeling Port LabelPort Description 10/100BASE-T PortsPoE and PoE+ Ports Dual-Purpose Gigabit Ethernet Ports 10/100 Mb/s SFP Module Slots100/1000 Mb/s SFP Module Slots Supported SFPs Type of SFP Module ModelLEDs SYSPoE Router Compact Flash Memory Cards CF0 Label on Cisco IOS Router Description Interface NameCF1 Installation Warning Statements InstallationPre-Installation Installation Removing the Slot Divider From the CGR 2010 Router Installing the Switch Module in the CGR 2010 Router Connecting to the Network Connecting the Copper Switch ModuleConnecting the Fiber Switch Module Connecting the Copper Model to the NetworkRemoving the Switch Module Connecting the SFP Fiber Model to the NetworkOL-23421-02 System Requirements Express SetupExpress Setup Recessed Express Setup Button Express Setup Window Field Description Vlan IDProblem Resolution Troubleshooting Express SetupResetting the Switch Module Follow the steps in Express Setup, Cisco Configuration Professional Managing the Switch ModuleUsing the Device Manager Accessing the Switch Module Other Management OptionsInterface IP Address Method Status ProtocolPurpose Disconnecting from the Switch ModuleCommand Purpose Connecting Devices to the Switch Module SFP Module Slots 237941 Dual-Purpose Port with RJ-45 and SFP Connectors 237964 Dual-Purpose Connectors Verifying Port ConnectivityOL-23421-02 SFP Module Connectors Cable and ConnectorsConnector Specifications SFP Module Cables Cables and AdaptersDual-Purpose Ports Commercial SFPs Extended temperature SFPsCore Modal Wavelength MHz/km1 Cable Distance Cable PinoutsBandwidth Type of SFP Module Nanometers Fiber Type Figure A-6 OL-23421-02