Chapter 3 Express Setup
Troubleshooting Express Setup
•Confirm that the computer that you are using to access the switch module has network connectivity by connecting to a web server in your network. If there is no network connection, troubleshoot the network settings on your computer.
•Verify that the switch module IP address in the browser is correct. If it is correct, the port LED is green and the computer has network connectivity. Continue troubleshooting by disconnecting and then reconnecting the switch module to your computer. Configure a static IP address on the computer that is in the same subnet as the switch module IP address.
When the LED on the switch module port that connects to the computer is green, open a web browser and enter the switch module IP address to display the Device Manager. When the Device Manager displays, you can continue with configuration.
Troubleshooting Express Setup
If you are still have problems running Express Setup, perform the checks in Table
Table
Problem | Resolution |
|
|
POST did not complete before | Verify that only the System and Port LEDs are green before you press |
you started Express Setup | the Express Setup button. |
| Note POST errors are usually fatal. Contact your Cisco technical |
| support representative if your switch module fails POST. |
|
|
Express Setup button was | Wait until POST completes, and then restart the switch module. Wait |
pressed before POST finished | until POST completes again, and then confirm that the System and |
| Port LEDs are green. Press the Express Setup button. |
|
|
Computer has a static IP | Change the settings on your computer to temporarily use DHCP |
address |
|
|
|
Ethernet is connected to the | Disconnect the cable from the Console port on the switch module. |
console port | Connect the cable to a blinking 10/100 Ethernet port on the switch |
| module. Wait 30 seconds, and then open a web browser. |
| Note The Console port is outlined in blue, and the Ethernet ports are |
| outlined in yellow. |
|
|
Cannot open a web browser to | Wait 30 seconds before opening a web browser on the computer |
start Express Setup |
|
|
|
Resetting the Switch Module
Caution Resetting the switch module deletes the configuration and restarts the switch module with default settings.
Step 1 Press and hold the Express Setup button for about 10 seconds. The switch module reboots. The system LED turns green after the switch module completes rebooting.
Cisco Connected Grid Ethernet Switch Module Interface Card Getting Started Guide
|
| ||
|
|