Cisco Systems OL-23421-02 manual Express Setup Window

Page 27

Chapter 3 Express Setup

Express Setup

Step 6 Select one of the following:

•For the Copper Model (GRWIC-D-ES-2S-8PC), connect a Cat 5 or 6 cable to the blinking 10/100BASE-T port, and the plug the other end to the Ethernet port on your computer

•For the SFP Fiber Model (GRWIC-D-ES-6S), connect a Category 5 or Category 6 cable to the 100/1000BASE-T port of the dual-purpose port (GE0/1), and then plug the other end to the Ethernet plug on your computer

Wait until the port LEDs on the switch module and your computer are either green or blinking green (indicates successful connection).

Tip If the port LEDs are not green after 30 seconds, verify you are using Cat 5 or 6 cable and that the cable is not damaged. Make sure the other devices are turned on. You can also verify the connection by pinging IP address 169.250.0.1.

Follow these steps to configure the switch module:

Step 1 Open a web browser and enter the switch module IP address.

Step 2 Enter cisco as the default username and password.

Figure 3-2 Express Setup Window

Tip If you cannot access Express Setup, verify that all pop-up blockers or proxy settings are disabled, and that any wireless client on your computer are disabled.

Cisco Connected Grid Ethernet Switch Module Interface Card Getting Started Guide

	OL-23421-02	3-3

Image 27

Contents Cisco Systems, Inc Page N T E N T S Other Management Options Preface PurposeDocument Conventions Related Publications Obtaining Documentation and Submitting a Service RequestGRWIC-D-ES-2S-8PC Switch ModelsMode Description Product OverviewPort Locations PortsPort Label Port Labeling10/100BASE-T Ports PoE and PoE+ PortsPort Description 10/100 Mb/s SFP Module Slots 100/1000 Mb/s SFP Module SlotsDual-Purpose Gigabit Ethernet Ports Type of SFP Module Model Supported SFPsSYS LEDsPoE Router Compact Flash Memory Cards Label on Cisco IOS Router Description Interface Name CF1CF0 Installation Pre-InstallationInstallation Warning Statements Installation Removing the Slot Divider From the CGR 2010 Router Installing the Switch Module in the CGR 2010 Router Connecting the Copper Switch Module Connecting to the NetworkConnecting the Copper Model to the Network Connecting the Fiber Switch ModuleConnecting the SFP Fiber Model to the Network Removing the Switch ModuleOL-23421-02 Express Setup Express SetupSystem Requirements Recessed Express Setup Button Express Setup Window Vlan ID Field DescriptionTroubleshooting Express Setup Resetting the Switch ModuleProblem Resolution Follow the steps in Express Setup, Managing the Switch Module Using the Device ManagerCisco Configuration Professional Method Status Protocol Accessing the Switch ModuleOther Management Options Interface IP AddressDisconnecting from the Switch Module Command PurposePurpose Connecting Devices to the Switch Module SFP Module Slots 237941 Dual-Purpose Port with RJ-45 and SFP Connectors 237964 Verifying Port Connectivity Dual-Purpose ConnectorsOL-23421-02 Cable and Connectors Connector SpecificationsSFP Module Connectors Cables and Adapters Dual-Purpose PortsSFP Module Cables Extended temperature SFPs Core Modal WavelengthCommercial SFPs Cable Pinouts Bandwidth Type of SFP Module Nanometers Fiber TypeMHz/km1 Cable Distance Figure A-6 OL-23421-02