Cisco Systems OL-23421-02 manual SFP Module Slots

Page 35

Chapter 4 Managing the Switch Module

Connecting Devices to the Switch Module

Figure 4-1

RJ-45 Ports

237940

Step 2 Connect the cable to the RJ-45 port on the other device.

Note The automatic medium-dependent interface crossover (auto-MDIX) feature is enabled by default. The switch detects the required cable type for copper Ethernet connections and configures the interfaces. You can use either a crossover or a straight-through cable for connections to a 10/100/1000 RJ-45 port on the switch module, regardless of the type of connected device.

SFP Module Slots

The switch module provides two 100/1000 Mb/s or Gigabit Ethernet SFP module slots ports: one standard Gigabit SFP module slot in the center (labeled GE0/2) and one SFP module slot for the dual-purpose port on the bottom (labeled GE0/1).

To connect to an SFP module slot:

Step 1 Grasp the SFP module on the sides, and insert it into the SFP module slot port until you feel the connector snap into place.

Caution Make sure that SFP module is right side up before attempting to insert the SFP module into the slot.

Cisco Connected Grid Ethernet Switch Module Interface Card Getting Started Guide

	OL-23421-02	4-5

Image 35

Contents Cisco Systems, Inc Page N T E N T S Other Management Options Document Conventions PrefacePurpose Related Publications Obtaining Documentation and Submitting a Service RequestGRWIC-D-ES-2S-8PC Switch ModelsMode Description Product OverviewPort Locations PortsPort Label Port LabelingPort Description 10/100BASE-T PortsPoE and PoE+ Ports Dual-Purpose Gigabit Ethernet Ports 10/100 Mb/s SFP Module Slots100/1000 Mb/s SFP Module Slots Type of SFP Module Model Supported SFPsSYS LEDsPoE Router Compact Flash Memory Cards CF0 Label on Cisco IOS Router Description Interface NameCF1 Installation Warning Statements InstallationPre-Installation Installation Removing the Slot Divider From the CGR 2010 Router Installing the Switch Module in the CGR 2010 Router Connecting the Copper Switch Module Connecting to the NetworkConnecting the Copper Model to the Network Connecting the Fiber Switch ModuleConnecting the SFP Fiber Model to the Network Removing the Switch ModuleOL-23421-02 System Requirements Express SetupExpress Setup Recessed Express Setup Button Express Setup Window Vlan ID Field DescriptionProblem Resolution Troubleshooting Express SetupResetting the Switch Module Follow the steps in Express Setup, Cisco Configuration Professional Managing the Switch ModuleUsing the Device Manager Method Status Protocol Accessing the Switch ModuleOther Management Options Interface IP AddressPurpose Disconnecting from the Switch ModuleCommand Purpose Connecting Devices to the Switch Module SFP Module Slots 237941 Dual-Purpose Port with RJ-45 and SFP Connectors 237964 Verifying Port Connectivity Dual-Purpose ConnectorsOL-23421-02 SFP Module Connectors Cable and ConnectorsConnector Specifications SFP Module Cables Cables and AdaptersDual-Purpose Ports Commercial SFPs Extended temperature SFPsCore Modal Wavelength MHz/km1 Cable Distance Cable PinoutsBandwidth Type of SFP Module Nanometers Fiber Type Figure A-6 OL-23421-02