Cisco Systems OL-23421-02 manual Cables and Adapters, Dual-Purpose Ports, SFP Module Cables

Page 42

Appendix A Cable and Connectors

Cables and Adapters

Figure A-2 Fiber-Optic SFP Module LC Connector

58476

Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or view directly with optical instruments. Statement 1051

Dual-Purpose Ports

The 10/100/1000BASE-T ports on the dual-purpose ports use RJ-45 connectors. Figure A-3shows the pinouts.

Figure A-3 10/100/1000 Port Pinouts

Pin Label

1TP0+

2TP0-

3TP1+

4TP2+

5TP2-

6TP1-

7TP3+

8TP3-

1 2 3 4 5 6 7 8

60915

Cables and Adapters

•SFP Module Cables, page A-2

•Cable Pinouts, page A-4

SFP Module Cables

Each port must match the wave-length specifications on each end of the cable, and for reliable communications, the cable must not exceed the allowable length.

Note The maximum operating temperature of the switch varies depending on the type of SFP module that you use. See the “Supported SFP Models” table in the “Supported SFPs” section on page 1-6for information on the supported temperature ranges.

Cisco Connected Grid Ethernet Switch Module Interface Card Getting Started Guide

	A-2	OL-23421-02

Image 42

Contents Cisco Systems, Inc Page N T E N T S Other Management Options Preface PurposeDocument Conventions Obtaining Documentation and Submitting a Service Request Related PublicationsProduct Overview Switch ModelsMode Description GRWIC-D-ES-2S-8PCPorts Port LocationsPort Labeling Port Label10/100BASE-T Ports PoE and PoE+ PortsPort Description 10/100 Mb/s SFP Module Slots 100/1000 Mb/s SFP Module SlotsDual-Purpose Gigabit Ethernet Ports Supported SFPs Type of SFP Module ModelLEDs SYSPoE Router Compact Flash Memory Cards Label on Cisco IOS Router Description Interface Name CF1CF0 Installation Pre-InstallationInstallation Warning Statements Installation Removing the Slot Divider From the CGR 2010 Router Installing the Switch Module in the CGR 2010 Router Connecting to the Network Connecting the Copper Switch ModuleConnecting the Fiber Switch Module Connecting the Copper Model to the NetworkRemoving the Switch Module Connecting the SFP Fiber Model to the NetworkOL-23421-02 Express Setup Express SetupSystem Requirements Recessed Express Setup Button Express Setup Window Field Description Vlan IDTroubleshooting Express Setup Resetting the Switch ModuleProblem Resolution Follow the steps in Express Setup, Managing the Switch Module Using the Device ManagerCisco Configuration Professional Interface IP Address Accessing the Switch ModuleOther Management Options Method Status ProtocolDisconnecting from the Switch Module Command PurposePurpose Connecting Devices to the Switch Module SFP Module Slots 237941 Dual-Purpose Port with RJ-45 and SFP Connectors 237964 Dual-Purpose Connectors Verifying Port ConnectivityOL-23421-02 Cable and Connectors Connector SpecificationsSFP Module Connectors Cables and Adapters Dual-Purpose PortsSFP Module Cables Extended temperature SFPs Core Modal WavelengthCommercial SFPs Cable Pinouts Bandwidth Type of SFP Module Nanometers Fiber TypeMHz/km1 Cable Distance Figure A-6 OL-23421-02