Cisco Systems OL-23421-02 manual Removing the Switch Module

Page 23

Chapter 2 Installation

Removing the Switch Module

Figure 2-6 Connecting the SFP Fiber Model to the Network

237942

Step 2 Connect the other end of the cable to the standard LC-type optical connector on the target device.

Removing the Switch Module

Caution The Cisco CGR 2010 router does not support removing modules when the chassis is powered on. Removing the switch module when the router is running can result in undesirable behavior, such as resetting the router or damage to the router.

Follow these steps to remove the switch module from the host router:

Step 1 Power down the CGR 2010 router as described in “Shutting Off Power” in Chapter 3 of the Cisco Connected Grid Router 2010 Hardware Installation Guide.

Step 2 Remove the three captive screws and the two screws at the top and bottom center of the module. Step 3 Grasp the handles firmly with both hands and carefully pull out the switch module.

Step 4 Power up the router when ready to do so.

Cisco Connected Grid Ethernet Switch Module Interface Card Getting Started Guide

	OL-23421-02	2-7

Image 23

Contents Cisco Systems, Inc Page N T E N T S Other Management Options Document Conventions PrefacePurpose Related Publications Obtaining Documentation and Submitting a Service RequestGRWIC-D-ES-2S-8PC Switch ModelsMode Description Product OverviewPort Locations PortsPort Label Port LabelingPort Description 10/100BASE-T PortsPoE and PoE+ Ports Dual-Purpose Gigabit Ethernet Ports 10/100 Mb/s SFP Module Slots100/1000 Mb/s SFP Module Slots Type of SFP Module Model Supported SFPsSYS LEDsPoE Router Compact Flash Memory Cards CF0 Label on Cisco IOS Router Description Interface NameCF1 Installation Warning Statements InstallationPre-Installation Installation Removing the Slot Divider From the CGR 2010 Router Installing the Switch Module in the CGR 2010 Router Connecting the Copper Switch Module Connecting to the NetworkConnecting the Copper Model to the Network Connecting the Fiber Switch ModuleConnecting the SFP Fiber Model to the Network Removing the Switch ModuleOL-23421-02 System Requirements Express SetupExpress Setup Recessed Express Setup Button Express Setup Window Vlan ID Field DescriptionProblem Resolution Troubleshooting Express SetupResetting the Switch Module Follow the steps in Express Setup, Cisco Configuration Professional Managing the Switch ModuleUsing the Device Manager Method Status Protocol Accessing the Switch ModuleOther Management Options Interface IP AddressPurpose Disconnecting from the Switch ModuleCommand Purpose Connecting Devices to the Switch Module SFP Module Slots 237941 Dual-Purpose Port with RJ-45 and SFP Connectors 237964 Verifying Port Connectivity Dual-Purpose ConnectorsOL-23421-02 SFP Module Connectors Cable and ConnectorsConnector Specifications SFP Module Cables Cables and AdaptersDual-Purpose Ports Commercial SFPs Extended temperature SFPsCore Modal Wavelength MHz/km1 Cable Distance Cable PinoutsBandwidth Type of SFP Module Nanometers Fiber Type Figure A-6 OL-23421-02