Cisco Systems 12000 series manual Hardware pfc mode keywords, Connected keywords, CF-794

show platform

Command History		Release				Modification
		12.2(14)SX				Support for this command was introduced on the Supervisor Engine 720.
		12.2(17d)SXB				Support for this command on the Supervisor Engine 2 was extended to
						Release 12.2(17d)SXB. This command was changed to include the
						hardware pfc mode keywords.
		12.2(18)SXD				This command was changed to include the software ipv6-multicast
						connected keywords.
		12.2(33)SRA				This command was integrated into Cisco IOS Release 12.2(33)SRA.
		12.2(33)SRC				This command was modified to include additional keywords to support
						CoPP enhancements on the Cisco SIP-400 on the Cisco 7600 series router.
		This command is similar to the show msfc command.
Usage Guidelines
Examples		This example shows how to display buffer-allocation information:
		Router# show platform buffers
		Reg. set		Min		Max
		TX				640
		ABQ		640	16384
	0			0		40
	1			6715	8192
	2			0		0
	3			0		0
	4			0		0
	5			0		0
	6			0		0
	7			0		0
		Threshold = 8192
		Vlan	Sel	Min	Max	Cnt	Rsvd
	1019		1 6715		8192	0	0

Router#

Cisco 7600 Series Routers with Cisco 7600 SIP-400

This example shows how to display the list of interfaces on which a rate limiter is active for Address Resolution Protocol (ARP), along with the count of confirmed and exceeded packets for the rate limiter.

Router# show platform copp rate-limit arp

Rate limiter Information for Protocol arp:

Rate Limiter Status: Enabled
Rate : 20 pps
Max Observation Period : 60 seconds
Per Interface Rate Limiter Information
Interface	Conformed Pkts	Exceeded Pkts	Enabled	Obs Period (Mts)
GigabitEthernet5/1	0	0	No	-
GigabitEhternet5/1.1	14	0	No	-
GigabitEthernet5/1.2	28	2	No	-
GigabitEthernet5/2	0	0	No	-
GigabitEthernet5/2.1	180	4	Yes	35
GigabitEthernet5/2.2	200	16	Yes	Max

	Router#
	Cisco IOS Configuration Fundamentals Command Reference
CF-794	July 2008