Cisco Systems 12000 series Running-config all command, Cisco 7600 Series Router, Output, CF-871

show running-config

•The show running-configcommand does not display this value.

•The show running-config all displays this output: cdp holdtime 180.

If the Cisco Discovery Protocol holdtime is changed to a nondefault value (for example, 100), the output of the show running-configand show running-config all commands is the same; that is, the configured parameter is displayed.

Note		In Release 12.2(33)SXH, implementation of the all keyword expands the output to include some of the
		commands that are configured with default values. In subsequent Cisco IOS releases, additional
		configuration commands that are configured with default values will be added to the output of the show
		running-config all command.
		Cisco 7600 Series Router
		In some cases, you might see a difference in the duplex mode that is displayed between the show
		interfaces command and the show running-configcommand. The duplex mode that is displayed in the
		show interfaces command is the actual duplex mode that the interface is running. The show interfaces
		command displays the operating mode for an interface, and the show running-configcommand displays
		the configured mode for an interface.
		The show running-configcommand output for an interface might display the duplex mode but no
		configuration for the speed. This output indicates that the interface speed is configured as auto and that
		the duplex mode shown becomes the operational setting once the speed is configured to something other
		than auto. With this configuration, it is possible that the operating duplex mode for that interface does
		not match the duplex mode that is displayed with the show running-configcommand.
Examples		The following example shows the configuration for serial interface 1:
		Router# show running-config interface serial 1
		Building configuration...
		Current configuration:
	!
		interface Serial1
		no ip address
		no ip directed-broadcast
		no ip route-cache
		no ip mroute-cache
		shutdown
		end
		The following example shows the configuration for Ethernet interface 0/0. Line numbers are displayed
		in the output.
		Router# show running-config interface ethernet 0/0 linenum
		Building configuration...

Current configuration : 104 bytes 1 : !

2 : interface Ethernet0/0

3 : ip address 10.4.2.63 255.255.255.0

4: no ip route-cache

5: no ip mroute-cache

6: end

	Cisco IOS Configuration Fundamentals Command Reference
July 2008		CF-871