show protocols
show protocols
To display the configured protocols, use the show protocols command in EXEC mode.
This command shows the global and
show protocols
Syntax Description This command has no arguments or keywords.
Command Modes
Command History
EXEC
Release | Modification |
10.0 | This command was introduced. |
|
|
12.2(33)SRA | This command was integrated into Cisco IOS Release 12.2(33)SRA. |
|
|
Examples | The following is sample output from the show protocols command: |
| Router# show protocols |
| Global values: |
| Internet Protocol routing is enabled |
| DECNET routing is enabled |
| XNS routing is enabled |
| Appletalk routing is enabled |
| X.25 routing is enabled |
| Ethernet 0 is up, line protocol is up |
| Internet address is 192.168.1.1, subnet mask is 255.255.255.0 |
| Decnet cost is 5 |
| XNS address is 2001.AA00.0400.06CC |
| AppleTalk address is 4.129, zone Twilight |
| Serial 0 is up, line protocol is up |
| Internet address is 192.168.7.49, subnet mask is 255.255.255.240 |
| Ethernet 1 is up, line protocol is up |
| Internet address is 192.168.2.1, subnet mask is 255.255.255.0 |
| Decnet cost is 5 |
| XNS address is 2002.AA00.0400.06CC |
| AppleTalk address is 254.132, zone Twilight |
| Serial 1 is down, line protocol is down |
| Internet address is 192.168.7.177, subnet mask is 255.255.255.240 |
| AppleTalk address is 999.1, zone Magnolia Estates |
| For more information on the parameters or protocols shown in this sample output, see the Cisco IOS |
| Network Protocols Configuration Guide, Part 1, Network Protocols Configuration Guide, Part 2, and |
| Network Protocols Configuration Guide, Part 3. |
| Cisco IOS Configuration Fundamentals Command Reference |
| July 2008 |