Cisco Systems PAP2 Enter the IP, Address Address using, 140, Format Check Firmware 150, Version

Page 19

Phone Adapter with 2 Ports for Voice-over-IP

Interactive Voice Response Menu

Action	Command	Choices	Description
	(press these
	keys on the
	telephone)

Set Static Gateway IP	131	Enter the IP	To set a static gateway IP address, the
Address		address using	DHCP feature must be disabled. If the
		numbers on the	DHCP feature is enabled, then you will
		telephone keypad.	hear, “Invalid Option,” if you try to set
		Use the * (star) key	a static gateway IP address.
		when entering a
		decimal point.

Check MAC Address	140		You will hear the MAC address of the
			Phone Adapter in hexadecimal string
			format.

Check Firmware	150		You will hear the version number of
Version			the firmware currently installed on the
			Phone Adapter.

Manual Reboot	732668		After you hear, “Option successful,”
			hang up the phone. The Phone
			Adapter will automatically reboot.

Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu			13

Using the Interactive Voice Response Menu

Image 19

Contents Phone Adapter Page Copyright and Trademarks How to Use this GuidePhone Adapter with 2 Ports for Voice-over-IP Table of Contents Front Panel Back PanelWelcome IntroductionWhat’s in this Guide? Introduction Back Panel Ports Getting to Know the Phone AdapterAn incoming call has been detected Front PanelPhone Adapter’s LEDs are located on the front panel Incoming call has been detectedInternet Connecting the Phone AdapterInstructions for Connecting the Phone Adapter OverviewConnect the Telephone Cable Follow the instructions provided by VonagePhone Adapter’s Interactive Voice Response Menu Placement OptionsStand Option Remove the plate from the Phone Adapter’s bottom panelMeasurement between Wall-Mount Slots Wall-Mount OptionAccessing the Interactive Voice Response Menu Using the Phone Adapter’s Interactive Voice Response MenuUsing the Interactive Voice Response Menu Key or hang up to exit Use this command to enter Response MenuInteractive Voice Response Menu Not press any other keys until youCheck Dhcp 100 Has been enabled or disabled. If101 Enter 1 to enable Enter 0 to disableNetwork mask When entering a Decimal point Address usingStatic IP address When entering a Decimal point Subnet Mask Mask using131 Enter the IP Address Address usingStatic gateway IP address When entering a Decimal point Phone Adapter Manual Reboot 732668Configuring the Settings for Your Internet Phone Service Common Problems and Solutions Appendix a TroubleshootingAppendix a Troubleshooting IP address Phone Adapter Internet phone 69 to Application Start and End Protocol IP Address EnableInternet phone 5060 to IP address Phone Adapter Internet phone 53 toPhone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Ethernet LED does not light up Frequently Asked QuestionsCan I make calls while I’m browsing the Internet? Shared Resources Appendix B Windows HelpNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Storage Humidity ~90% Non-Condensing Dimensions 98 x 3.98 x H x DMm x 101 mm x 15 mm Limited Warranty Appendix E Warranty InformationAppendix E Warranty Information FCC Statement Appendix F Regulatory InformationAppendix F Regulatory Information Linksys VonageToll-free from US