Cisco Systems PAP2 manual Application Start and End Protocol IP Address Enable

Page 25

Phone Adapter with 2 Ports for Voice-over-IP

5.For each port range you must specify, enter a different name in the Application field. Then enter the number or range of external port(s) used by the Phone Adapter.

6.Select the protocol you will be using, UDP.

7.Enter the IP address of the Phone Adapter. For example, if the Phone Adapter’s IP address is 192.168.1.100, you would enter 100 in the field provided.

8.Repeat steps 5-7 until you have entered all four port ranges for the Phone Adapter.

Application	Start and End	Protocol	IP Address	Enable

Internet phone 1	5060 to 5061	UDP	(IP address of	X
			Phone Adapter)

Internet phone 2	53 to 53	UDP	(IP address of	X
			Phone Adapter)

Internet phone 3	69 to 69	UDP	(IP address of	X
			Phone Adapter)

Internet phone 4	10000 to 20000	UDP	(IP address of	X
			Phone Adapter)

9.Check the Enable option for the port services you want to use.

10.When you have completed the configuration, click the Save Settings button.

Appendix A: Troubleshooting

19

Common Problems and Solutions

Image 25

Contents Phone Adapter Page Copyright and Trademarks How to Use this GuidePhone Adapter with 2 Ports for Voice-over-IP Table of Contents Front Panel Back PanelWelcome IntroductionWhat’s in this Guide? Introduction Back Panel Ports Getting to Know the Phone AdapterPhone Adapter’s LEDs are located on the front panel Front PanelIncoming call has been detected An incoming call has been detectedInstructions for Connecting the Phone Adapter Connecting the Phone AdapterOverview InternetConnect the Telephone Cable Follow the instructions provided by VonageStand Option Placement OptionsRemove the plate from the Phone Adapter’s bottom panel Phone Adapter’s Interactive Voice Response MenuMeasurement between Wall-Mount Slots Wall-Mount OptionAccessing the Interactive Voice Response Menu Using the Phone Adapter’s Interactive Voice Response MenuUsing the Interactive Voice Response Menu Interactive Voice Response Menu Use this command to enter Response MenuNot press any other keys until you Key or hang up to exit101 Enter 1 to enable Has been enabled or disabled. IfEnter 0 to disable Check Dhcp 100Static IP address When entering a Decimal point Address usingSubnet Mask Mask using Network mask When entering a Decimal pointStatic gateway IP address When entering a Decimal point Address Address usingPhone Adapter Manual Reboot 732668 131 Enter the IPConfiguring the Settings for Your Internet Phone Service Common Problems and Solutions Appendix a TroubleshootingAppendix a Troubleshooting Internet phone 5060 to Application Start and End Protocol IP Address EnableIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 toPhone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Ethernet LED does not light up Frequently Asked QuestionsCan I make calls while I’m browsing the Internet? Shared Resources Appendix B Windows HelpNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Storage Humidity ~90% Non-Condensing Dimensions 98 x 3.98 x H x DMm x 101 mm x 15 mm Limited Warranty Appendix E Warranty InformationAppendix E Warranty Information FCC Statement Appendix F Regulatory InformationAppendix F Regulatory Information Linksys VonageToll-free from US