Cisco Systems PAP2 manual Appendix C Glossary

Page 33

Phone Adapter with 2 Ports for Voice-over-IP

Appendix C: Glossary

Adapter - A device that adds network functionality to your PC.

Backbone - The part of a network that connects most of the systems and networks together, and handles the most data.

Bandwidth - The transmission capacity of a given device or network.

Bit - A binary digit.

Boot - To start a device and cause it to start executing instructions.

Bridge - A device that connects different networks.

Broadband - An always-on, fast Internet connection.

Browser - An application program that provides a way to look at and interact with all the information on the World Wide Web.

Buffer - A shared or assigned memory area that is used to support and coordinate different computing and networking activities so one isn't held up by the other.

Byte - A unit of data that is usually eight bits long

Cable Modem - A device that connects a computer to the cable television network, which in turn connects to the Internet.

CSMA/CA (Carrier Sense Multiple Access/Collision Avoidance) - A method of data transfer that is used to prevent data collisions.

CTS (Clear To Send) - A signal sent by a wireless device, signifying that it is ready to receive data.

Daisy Chain - A method used to connect devices in a series, one after the other.

Appendix C: Glossary

27

Image 33

Contents Phone Adapter Page Copyright and Trademarks How to Use this GuidePhone Adapter with 2 Ports for Voice-over-IP Table of Contents Front Panel Back PanelIntroduction WelcomeWhat’s in this Guide? Introduction Back Panel Ports Getting to Know the Phone AdapterPhone Adapter’s LEDs are located on the front panel Front PanelIncoming call has been detected An incoming call has been detectedInstructions for Connecting the Phone Adapter Connecting the Phone AdapterOverview InternetConnect the Telephone Cable Follow the instructions provided by VonageStand Option Placement OptionsRemove the plate from the Phone Adapter’s bottom panel Phone Adapter’s Interactive Voice Response MenuMeasurement between Wall-Mount Slots Wall-Mount OptionUsing the Phone Adapter’s Interactive Voice Response Menu Accessing the Interactive Voice Response MenuUsing the Interactive Voice Response Menu Interactive Voice Response Menu Use this command to enter Response MenuNot press any other keys until you Key or hang up to exit101 Enter 1 to enable Has been enabled or disabled. IfEnter 0 to disable Check Dhcp 100Static IP address When entering a Decimal point Address usingSubnet Mask Mask using Network mask When entering a Decimal pointStatic gateway IP address When entering a Decimal point Address Address usingPhone Adapter Manual Reboot 732668 131 Enter the IPConfiguring the Settings for Your Internet Phone Service Common Problems and Solutions Appendix a TroubleshootingAppendix a Troubleshooting Internet phone 5060 to Application Start and End Protocol IP Address EnableIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 toPhone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Ethernet LED does not light up Frequently Asked QuestionsCan I make calls while I’m browsing the Internet? Appendix B Windows Help Shared ResourcesNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Dimensions 98 x 3.98 x H x D Storage Humidity ~90% Non-CondensingMm x 101 mm x 15 mm Limited Warranty Appendix E Warranty InformationAppendix E Warranty Information FCC Statement Appendix F Regulatory InformationAppendix F Regulatory Information Vonage LinksysToll-free from US