Cisco Systems PAP2 manual Appendix D Specifications

Page 39

Phone Adapter with 2 Ports for Voice-over-IP

Appendix D: Specifications

Model	PAP2
Standards	SIP v2 Session Initiation Protocol (RFC 3261, 3262, 3263, 3264)
Voice Codecs	G.729 A+B, G.711 a-law, G.711µ-law, G.726
Ports	Power, Ethernet, Phone 1, Phone 2
Cabling Type	CAT 5 (RJ45) for Ethernet Port and RJ11 for Phone Ports
LEDs	Power, Ethernet, Phone 1, Phone 2
Maximum Ringer Load	5 REN
Ring Frequency	10-40 Hz
FXS Port Impedance	Eight Configurable Settings Including North America 600 ohms,
	European CTR21
Ring Voltage	60-90 Vrms Configurable
Security Features	Password Protected Administration

Appendix D: Specifications

33

Image 39

Contents Phone Adapter Page Copyright and Trademarks How to Use this GuidePhone Adapter with 2 Ports for Voice-over-IP Table of Contents Front Panel Back PanelIntroduction WelcomeWhat’s in this Guide? Introduction Back Panel Ports Getting to Know the Phone AdapterAn incoming call has been detected Front PanelPhone Adapter’s LEDs are located on the front panel Incoming call has been detectedInternet Connecting the Phone AdapterInstructions for Connecting the Phone Adapter OverviewConnect the Telephone Cable Follow the instructions provided by VonagePhone Adapter’s Interactive Voice Response Menu Placement OptionsStand Option Remove the plate from the Phone Adapter’s bottom panelMeasurement between Wall-Mount Slots Wall-Mount OptionUsing the Phone Adapter’s Interactive Voice Response Menu Accessing the Interactive Voice Response MenuUsing the Interactive Voice Response Menu Key or hang up to exit Use this command to enter Response MenuInteractive Voice Response Menu Not press any other keys until youCheck Dhcp 100 Has been enabled or disabled. If101 Enter 1 to enable Enter 0 to disableNetwork mask When entering a Decimal point Address usingStatic IP address When entering a Decimal point Subnet Mask Mask using131 Enter the IP Address Address usingStatic gateway IP address When entering a Decimal point Phone Adapter Manual Reboot 732668Configuring the Settings for Your Internet Phone Service Common Problems and Solutions Appendix a TroubleshootingAppendix a Troubleshooting IP address Phone Adapter Internet phone 69 to Application Start and End Protocol IP Address EnableInternet phone 5060 to IP address Phone Adapter Internet phone 53 toPhone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Ethernet LED does not light up Frequently Asked QuestionsCan I make calls while I’m browsing the Internet? Appendix B Windows Help Shared ResourcesNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Dimensions 98 x 3.98 x H x D Storage Humidity ~90% Non-CondensingMm x 101 mm x 15 mm Limited Warranty Appendix E Warranty InformationAppendix E Warranty Information FCC Statement Appendix F Regulatory InformationAppendix F Regulatory Information Vonage LinksysToll-free from US