Cisco Systems Unified MeetingPlace Web Conferencing manual Configure a Single NIC with Both IP

Chapter 2 Installing Web Conferencing

Installation Tasks: Web Conferencing

One NIC enabled and configured with two IP addresses;	• Only utilizes one of the two NICs on the
second NIC is disabled	system.
	• The NIC is a single point of failure.
	• This configuration is available for both HP
	and IBM MCS server models
	• To configure this option, perform the “To
	Configure a Single NIC with Both IP
	Addresses on the Cisco MCS Server”
	procedure on page 2-7.
Both NICs enabled, one IP address per NIC	• Each NIC on the system is used, although one
	NIC may be more heavily used than the other.
	• Each NIC is a single point of failure. If either
	NIC fails, Web Conferencing will be
	unavailable.
	• If the Web Conferencing server is connected
	to a 100 MB/sec. network, the NIC capacity
	may be exceeded in large meetings with
	heavy application sharing.
	• This configuration is available for both HP
	and IBM MCS server models.
	• To configure this option, perform the “To
	Configure One IP Address per NIC on the
	Cisco MCS Server” procedure on page 2-8.

Installation and Upgrade Guide for Cisco Unified MeetingPlace Web Conferencing Release 6.x

2-6 OL-13418-01