Cisco Systems AS5400XM quick start RJ-45 jack E1 cable

•Connect each E1/PRI port to an RJ-45 jack with a straight-through RJ-45-to-RJ-45 cable. (See Figure 25, Figure 26, and Figure 27.)

Note If you choose a port with 75-ohm input impedance, use an RJ-45-to-75-ohm coaxial cable adapter and plug it into

that port. Use software commands to choose a particular port and the line termination on that port. For information on software commands, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide.

Warning	The E1 interface card may only be installed in an ACA-permitted customer equipment or a Data Terminal Equipment
	(DTE) that is exempted from ACA’s permit requirements. The customer equipment must only be housed in a cabinet
	that has screw-down lids to stop user access to overvoltages on the customer equipment. The customer equipment
	has circuitry that may have telecommunications network voltages on them. Statement 90
Figure 25	Connecting a 2-Port or 4-Port Feature Card on the Cisco AS5350XM Universal Gateway to an RJ-45 Jack

35673

RJ-45 jack

E1 cable

21