Cisco Systems AS5400XM Verifying the Group Interface Configuration, Gateway# show async status

Page 41

Step 4 Define the slot/port group range of the interface. The range that you specify depends on the number of asynchronous interfaces you have on your gateway. If your gateway has 108 asynchronous interfaces, you can specify group-range 1/1 1/107.

Gateway(config-if)# group-rangeslot/port slot/port

Building configuration...

Gateway(config-if)#

Step 5 Return to privileged EXEC mode:

Gateway(config-if)# Ctrl-Z

Gateway#

Tip To save the gateway configuration, save it to NVRAM. See the “Saving Configuration Changes” section on page 60.

Verifying the Group Interface Configuration

To verify your group interface configuration, enter the show interface async command in privileged EXEC mode:

Gateway# show interface async 4/0

Async4/00 is down, line protocol is down modem(slot/port)=4/0, state=IDLE dsx1(slot/unit/channel)=NONE, status=VDEV_STATUS_UNLOCKED Hardware is Async Serial

MTU 1500 bytes, BW 115 Kbit, DLY 100000 usec, reliability 255/255, txload 1/255, rxload 1/255

Encapsulation SLIP, loopback not set DTR is pulsed for 5 seconds on reset

Last input never, output never, output hang never Last clearing of "show interface" counters never

Input queue: 0/10/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: weighted fair

Output queue: 0/1000/64/0 (size/max total/threshold/drops) Conversations 0/1/32 (active/max active/max total) Reserved Conversations 0/0 (allocated/max allocated) Available Bandwidth 86 kilobits/sec

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 0 packets output, 0 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions

If you are having trouble, check for errors as well as local and remote addresses. Enter the show async status command in privileged EXEC mode:

Gateway# show async status

Async protocol statistics:

Int

Local

Remote

Qd

InPack

OutPac

Inerr

Drops

MTU

1/00

42.1.1.1

None

0

0

0

0

0

1500

1/01

192.168.10.100

None

0

0

0

0

0

1500

1/02

192.168.10.100

None

0

0

0

0

0

1500

1/03

192.168.10.100

None

0

0

0

0

0

1500

1/04

192.168.10.100

None

0

0

0

0

0

1500

1/05

192.168.10.100

None

0

0

0

0

0

1500

41

Image 41
Contents Cisco AS5350XM and Cisco AS5400XM Universal Gateways Duration of Hardware Warranty Cisco 90-Day Limited Hardware Warranty TermsReplacement, Repair, or Refund Policy for Hardware To Receive a Return Materials Authorization RMA NumberCisco IOS Software Documentation Documents, Equipment, and ToolsUser Documentation New Feature Documentation Command ReferencesItems Not Included Release NotesSafety Information Install ChassisSetting Up the Chassis Rack-Mounting the ChassisAttaching Brackets Required Tools and EquipmentInstallation in a Rack Desktop InstallationCisco AS5350XM Universal Gateway Ground Lug Attachment Chassis Ground ConnectionInstalling a Carrier Card Install ModulesInstalling Carrier Cards Blank Feature Card Cover While the housing is open. Statement Installing Feature CardsDFC State Description Feature CardLED Color or Port or Connection Type Cable System Management and Power ConnectionsConnect Cables Port or Connection Color or Type Cable WAN, LAN, and Voice ConnectionsConnect a Console Terminal Console port RJ-45 Connect to an Ethernet Network Connect to a WAN T1/E1 8 PRI Connector RJ-45 jack E1 cable Cable RJ-45 jack T3 DFC Internet Situation. Statement StatementPin1 Description Connect AC Power Position. Statement Connect DC PowerLast. Statement Power switch To DC sourceCisco AS5400XM Universal Gateway DC Power Supply Connections Checklist for Power Up Power Up the Universal GatewayPower-Up Procedure Initial Configuration Using the Setup Command Facility Perform Initial ConfigurationEnter a hostname for the gateway Press Enter for every slot, port, and channel Router# configure terminal Initial Configuration Using the CLI Manual ConfigurationVerifying the Hostname and Passwords Gateway# show privilege Configuring Local AAA SecurityGateway# configure terminal Configuring Basic Dial Access Gateway# ping Configuring the Asynchronous Group InterfaceGatewayconfig# interface group-async Gateway# show async status Verifying the Group Interface ConfigurationGateway# show interface async 4/0 Configuring a T1 or E1 Feature Card Gateway# show controller t1 1/7 Configuring a Channelized T3 Feature CardVerifying Channelized T1 or E1 Controller Operation Gateway# show controller t3 1/0 Verifying Channelized T3 Controller OperationConfiguring Isdn PRI Gatewayconfig# controller t3 7/016 Area Keyword Switch TypeGateway# show controller t1 1/0 Verifying Interface ConfigurationGateway# show isdn status Gateway# show isdn serviceGateway# show running-config Configuring the D Channels for Isdn Signaling Gatewayconfig-if#isdn incoming-voice modem Gatewayconfig# interface serial 1/023Gatewayconfig-if#ip address 172.16.254.254 Gateway# show interface serial 1/023 Configuring the Universal Port or Dial-Only Feature CardsVerifying D Channel Configuration SPE Firmware Feature DescriptionVerifying the SPE Configuration Gateway# show line Configuring the Voice Feature CardUpgrade DSP Firmware on the Voice Feature Card Feature Card Ports Configure ClockingVerifying the Firmware Upgrade Gateway# show voice dsp versionGatewayconfig# dial-tdm-clock priority 1 external Clocking Configuration ExamplesExternal Clock Free-Running ClockGatewayconfig# dial-tdm-clock priority 2 1/019 Gatewayconfig# dial-tdm-clock priority 2 4/6Gatewayconfig# dial-tdm-clock priority 3 free Verify ClockingCT3 Gateway# copy running-config startup-config Saving Configuration ChangesVoice over IP PrerequisitesFor new features associated with a software release Where to Go NextConfiguration Tasks Obtaining Documentation Slot NumberingCisco.com Product Documentation DVDOrdering Documentation Documentation FeedbackCisco Product Security Overview Cisco Technical Support & Documentation Website Reporting Security Problems in Cisco ProductsObtaining Technical Assistance Obtaining Additional Publications and Information Submitting a Service RequestDefinitions of Service Request Severity Page Page USA
Related manuals
Manual 104 pages 52.67 Kb