Cisco Systems RSP8 manual Performing a Fast Software Upgrade

Enabling High Availability Features

Performing a Fast Software Upgrade

To perform a Fast Software Upgrade (FSU), use the following commands beginning in privileged EXEC configuration mode:

	Command	Purpose
Step 1 Router# copy tftp slotslot-number:		Uses TFTP to copy a high availability Cisco IOS
		image onto the Flash memory card or Flash Disk of
		the active RSP.1
		• slotslot-number—Specifies the Flash memory
		card or Flash Disk of the active RSP.
	Address or name of remote host []? ip-address	The router prompts you for the IP address of the
		TFTP server.
		• ip-address—Specifies the IP address of the
		TFTP server that contains the new image.
	Name of file to copy []? imagename<Return>	The router prompts you for the name of the image file
	writing filename!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!	you are copying to the Flash memory card or Flash
		Disk.
		• imagename—Indicates the name of the image to
		be loaded onto the Flash memory card or Flash
		Disk.
	Destination filename? [imagename1] <Return>	The router prompts you to type the name under which
	Accessing tftp://host ip-address/file 'imagename' on
		you want the file to appear at the destination.
	ip-address.. found !
	11188128 bytes copied in 2280.664 secs (4906	• imagename1—Indicates the name of the image
	bytes/sec)	as it appears at the destination.
		Note Step 1 and Step 2 are the same. Step 1 applies
		to the active RSP, and Step 2 applies to the
		the standby RSP.

Route Switch Processor (RSP8) Installation and Configuration Guide

60 OL-4920-02