Maintenance Information
Step 4 Wait 15 seconds.
Step 5 Reinsert the standby RSP8.
This completes the procedure to remove and replace an interface processor.
Reloading a Failed RSP
When a new active RSP takes over ownership of the router, it automatically reboots the failed RSP as the standby RSP. You can also manually reload the failed RSP.
To manually reload a failed RSP from the active console, use the following command in privileged EXEC configuration mode:
Command | Purpose |
|
|
Router# | Reloads the inactive standby RSP card. |
|
|
Displaying a Stack Trace of an RSP
To access the state of the failed RSP in the form of a stack trace from the active console, use the following command in privileged EXEC configuration mode:
Command | Purpose |
|
|
Router# show stacks1 | Displays the stack trace and version information of the active |
| and the standby RSP cards. |
|
|
1.This command is documented in the “System Management Commands” chapter of the Cisco IOS Configuration Fundamentals Command Reference publication.
Displaying Other Information About the RSPs
For information about other commands that you can use to display information about the RSPs, see the “Monitoring and Maintaining the Active and Standby RSPs” section on page 64 .
Maintenance Information
This section includes the following RSP8 maintenance procedures:
•Saving and Retrieving a Configuration File, page 69
•Replacing and Upgrading DRAM DIMMs, page 74
•Recovering a Lost Password, page 78
Saving and Retrieving a Configuration File
This section describes the procedures for saving and retrieving a system configuration file using a TFTP server.
Route Switch Processor (RSP8) Installation and Configuration Guide
| 69 |
| |
|
|