Cisco Systems RSP8 manual PC Card Slots, Serial Ports, LED Label Color State Indication

Product Description

Table 2	RSP8 LEDs
LED Label		Color	State	Indication
Normal1		Green	On	RSP is on and receiving +5V.
CPU halt1		Green	Off	RSP is operating normally.
		Yellow	On	Processor hardware failure has been detected.
Master		Green	On	RSP is an active (HSA/HA configuration required).
Slave		Green	On	RSP is a standby RSP (HSA/HA configuration required).
Slot 0 PC Card		Green	On	Flash Disk or PC Card in this slot is being accessed.
Slot 1 PC Card		Green	On	Flash Disk or PC Card in this slot is being accessed.

1. The RSP8 controls these LEDs and turns them on in parallel to indicate that the system is operational.

PC Card Slots

The RSP8 has two PC Card slots available. Either slot can support a Flash memory card or a Flash Disk. Type I and Type II PC Cards can be used in PC Card slot 0 and slot 1. Type III PC Cards can be used in slot 1. Not all Flash memory cards or Flash Disks that are commercially available are supported.

Note Other Flash memory card or Flash Disk limitations might apply. For additional information, refer to the “Related Documentation” section on page 2 .

Serial Ports

Two asynchronous serial ports on the RSP8, labeled Console and Auxiliary, allow you to connect external terminal devices to monitor and manage the system. The console port is an Electronics Industries Association/Telecommunications Industry Association (EIA/TIA)-232 receptacle (female) that provides a data circuit-terminating equipment (DCE) interface for connecting a console terminal.

Note EIA/TIA-232 was known as recommended standard RS-232 before its acceptance as a standard by the

Electronic Industries Association (EIA) and Telecommunications Industry Association (TIA).

The auxiliary port is an EIA/TIA-232 plug (male) that provides a data terminal equipment (DTE) interface; the auxiliary port supports flow control and is often used to connect a modem, a channel service unit (CSU), or other optional equipment for Telnet management.

Route Switch Processor (RSP8) Installation and Configuration Guide

8 OL-4920-02